User manual D-LINK DIR-605L

[. . . ] Preface D-Link reserves the right to revise this publication and to make changes in the content hereof without obligation to notify any person or organization of such revisions or changes. 0 Date May 25th, 2010 • First release version Description Trademarks D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the United States or other countries. All other company or product names mentioned herein are trademarks or registered trademarks of their respective companies. This publication may not be reproduced, in whole or in part, without prior expressed written permission from D-Link Systems, Inc. [. . . ] Daylight Saving can also be configured to automatically adjust the time when needed. Time Zone: Select the Time Zone from the drop-down menu. Daylight Saving: To select Daylight Saving time manually, select enabled or disabled, and enter a start date and an end date for daylight saving time. Sync your Press this button to set the device’s time the same to Computer’s Time local PC. This will only connect to a server on the Internet, not a local server. NTP Server Used: Enter the NTP server or select one from the dropdown menu, then the DIR-600 will sync the same time to D-Link Internet time server. Manual: To manually input the time, enter the values in these fields for the Year, Month, Day, Hour, Minute, and Second and then click Save Settings. D-Link DIR-600 User Manual 35 Section 3 - Configuration E-mail Settings The Email feature can be used to send the system log files, router alert messages, and firmware update notification to your e-mail address. From Email This e-mail address will appear as the sender when Address: you receive a log file or firmware upgrade notification via e-mail. To Email Address: Enter the e-mail address where you want the e-mail sent. SMTP Server Enter the SMTP server address for sending Address: e-mail. If your SMTP server requires authentication, select this option. D-Link DIR-600 User Manual 36 Section 3 - Configuration System Settings Save Settings to Use this option to save the current router configuration Local Hard Drive: settings to a file on the hard disk of the computer you are using. You will then see a file dialog, where you can select a location and file name for the settings. Load Settings Use this option to load previously saved router from Local Hard configuration settings. First, use the Browse control Drive: to find a previously save file of configuration settings. Then, click the Load button to transfer those settings to the router. Restore to Factory This option will restore all configuration settings back Default Settings: to the settings that were in effect at the time the router was shipped from the factory. Any settings that have not been saved will be lost, including any rules that you have created. If you want to save the current router configuration settings, use the Save button above. reboot Device: Click to reboot the router. Clear Language This is to restore the device back to English version only. [. . . ] Step 4 Click Use the following IP address and enter an IP address that is on the same subnet as your network or the LAN IP address on your router. Example: If the router´s LAN IP address is 192. Make sure that the number you choose is not in use on the network. Set Default Gateway the same as the LAN IP address of your router (192. [. . . ]