User manual DA-LITE ADVANTAGE ELECTROL

[. . . ] DO NOT unpack fabric and roller assembly yet. Make sure to recheck measurement of case for proper installation clearance. Remove any protective foam or tape from case. CASE INSTALLATION 1. Hang case and attach to support structure with bolts. [. . . ] NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments. Place operating switch in "down" position. When the screen stops, turn the white "down" limit knob (Fig. 1) one turn counterclockwise. Test by raising picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained. Raise picture surface approximately two feet above desired level. Place operating switch in "off" position. Turn the white "down" limit knob (Fig. Test by raising picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained. WHITE ADJUSTMENT KNOB "DOWN" MOTOR POWER CONNECTOR MOTOR MOTOR MOUNT BRACKET BLACK ADJUSTMENT KNOB "UP" FIGURE 1 SCREEN ADJUSTMENT FOR 220/240V SCREENS WITHOUT BUILT-IN LOW VOLTAGE CONTROL Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments. Place operating switch in "down" position. When the screen stops, turn the white "down" limit knob (Fig. 2) one turn counterclockwise. Test by raising picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained. Raise picture surface approximately two feet above desired level. Place operating switch in "off" position. Turn the white "down" limit knob (Fig. Test by raising picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained. MOTOR POWER CONNECTOR MOTOR WHITE ADJUSTMENT KNOB "DOWN" MOTOR MOUNT BRACKET RED ADJUSTMENT KNOB "UP" FIGURE 2 6 SCREEN ADJUSTMENT FOR 120V SCREENS WITH A BUILT-IN LOW VOLTAGE CONTROL OR VPI 1. Locate the wall switch and remove the cover plate from the 3-button wall switch and remove the switch from the junction box. Locate the two tactile buttons on the back of the switch. [. . . ] If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment. To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses. THISWARRANTYISINLIEUOFALLOTHERWARRANTIES, EXPRESSORIMPLIED, INCLUDINGWARRANTIESASTOFITNESSFORUSEANDMERCHANTABILITY. Any implied warranties of fitness for use, or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. [. . . ]