User manual DA-LITE ADVANTAGE MANUAL WITH CSR

[. . . ] The POWER In PRESENTATION PRODUCTS Instruction Book for DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 www. da-lite. com e-mail: info@da-lite. com ADVANTAGE MANUAL WITH CSR (Controlled Screen Return) ® PRE-INSTALLATION 1. Carefully unpack case from shipping carton. [. . . ] Tighten bolts until trim flange is flush with ceiling. NOTE: For proper operation, screen assembly must be level after installation. SCREEN AND ROLLER ASSEMBLY INSTALLATION If your screen was shipped with the motor and roller already installed, skip this section. First remove the 2 screws from the ends (Fig. 1). Be sure to support the door during this step to avoid injury. Lift the door slightly and pull away from the edge of the case. Carefully unpack screen and roller assembly. Remove two 1/4-20 nuts from one roller mounting bracket. Slide bracket towards the end of the case. Insert one end of the roller into the mounting bracket. The mounting brackets have a foam pad that the slat bar will rest against. Be sure to install the roller assembly so the slat bar is positioned below these pads (Fig. Slide the mounting bracket onto the roller pin. Procedure is reverse of removal. OPERATING SCREEN 1. Pull down on pull bail until desired picture area is obtained. [. . . ] The CSR feature of this screen will allow the fabric to retract rapidly until about the last 6-12 inches of travel then it will slow and retract gently into the case. FIGURE 1 SLAT BAR FOAM PAD FIGURE 2 REMOVE 2 SCREWS TO REMOVE ACCESS DOOR 1 MOUNTING BRACKET ADVANTAGE MANUAL INSTALLATION 9-1/4" VARIABLE POSITION MOUNTING CHANNEL 6-1/16" 3/8" THREADED ROD (NOT INCLUDED) ATTACHED TO MOUNTING BRACKET 6-3/8" SELF-TRIMMING FLANGE 7-3/4" FINISHED CEILING SEE DETAIL A 3. 41" 3/8" THREADED ROD (NOT SUPPLIED) 6. 42" 7. 95" HANGER BRACKET 7. 75" DETAIL A 2 Printed in U. S. A. 3 85778 Rev. [. . . ]