User manual DA-LITE AVCT2-42J SCHEMA

[. . . ] Procedures for each method are as follows: Wall Mount 1. The wall mount bracket should be fastened to wall studs or some reinforcement within the wall. Concrete or brick walls require special fasteners and anchors. The wall bracket has holes spaced at 16" and 24" to align with most wall studs. [. . . ] The wall bracket has holes spaced at 16" and 24" to align with most wall studs. keep in mind you will need at least 2-3/4" between the ceiling and the top of the wall mount bracket to be able to position the case on the bracket. mount the screen case on the wall bracket as shown in figure 1. be sure the case is fully seated on the bracket. Tighten the stop screws against the wall bracket. Wall mOunT bRaCkET sTOP sCREW vIEWIng suRfaCE (audIEnCE sIdE) 2" CasE hOOk FIGURE 1 Ceiling Mount 1. be sure the ceiling has adequate reinforcement to attach the screen brackets. attach the ceiling brackets to the wall mount bracket using the supplied 5/16" x 3/4" bolts, washers and nuts. Position the ceiling bracket asssembly on the ceiling and attach with 5/16" bolts (not supplied). The bolts should be long enough to pass through the drywall or ceiling tile and penetrate at least 1-1/2" into the reinforcement in the ceiling. mount the screen on the wall bracket as shown in figure 2. Incorrect stopping position in downward direction. (b) "Down" limit switch out of adjustment 3. Incorrect stopping position in upward direction. (b) "Up" limit switch out of adjustment 4. NOTE: Screen will operate with a low pitched hum. (b) Contact da-lite at 800-622-3737 or 574-267-8101 (a) see instructions below. (b) Contact da-lite at 800-622-3737 or 574-267-8101 (a) Replace motor assembly. (a) defective brake. (a) Replace motor assembly. 5 6 LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS da-lite screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to da-lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory. This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered with or repaired by a person other than authorized da-lite personnel. da-lite's sole obligation under this warranty shall be to repair or to replace (at da-lite's option) the defective part of the merchandise. [. . . ] warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to da-lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory. This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered with or repaired by a person other than authorized da-lite personnel. da-lite's sole obligation under this warranty shall be to repair or to replace (at da-lite's option) the defective part of the merchandise. Returns for service should be made to your da-lite dealer. [. . . ]