User manual DA-LITE AVCT2C-42J SCHEMA

[. . . ] Make sure to recheck measurements of screen location before installation. Please Note: Motor Operator Projection Screen Models LADT, LADDT, LAD and LADD must be installed in accordance with the requirements of the Local Building Codes, the Canadian Electrical Code (CEC), CAN/CSA C22. 1 and the National Electric Code (NEC), NFPA 70. An appropriate disconnect device shall be provided as part of the building installation. DOOR SUPPORT SCREWS (NOT ALL SIZES) BOLTS ACCESS DOOR FIGURE 1 CASE INSTALLATION 1. The case provides multiple attachment points for bolts, cables, or threaded rod. [. . . ] Remove the square peg bracket from the motor end of the roller assembly. Remove the safety clip from the motor attachement bracket located in the motor end of the screen housing. Place the roller assembly into the case with the motor on the left side. The limit switches should be facing down. Line up the head of the motor with the motor attachment bracket. Loosen four bolts that secure pin end mounting bracket into housing. Lift pin end of roller into position and slide the bracket into the roller pin. Complete electrical hook-up by snapping motor 1/3 wire connectors into case connectors. Return to motor end and insert safety clip over casting bracket to secure motor end. DO NOT CUT TAPE ON FABRIC WITH A KNIFE OR ANY SHARP TOOL. Carefully remove tape strips securing picture surface around roller. "Up" Position Check for power across red and white leads. NOTE: Motor is a sealed assembly. (b) Blown facility fuse. (d) No power to operating switch or junction box. (e) Low voltage board has no power or blown transformer. Power at junction box (g) Thermal overload tripped. (h) Broken wire in the "up" position. (j) Defective motor, limit switch or capacitor. Capacitor burned out. (g) Let motor cool down for 15 minutes. Replace motor assembly. 5 TROUBLESHOOTING SYMPTOM 3. CAUSE (a) Spring has an obstruction not allowing door to open. (b) Low voltage board has no power or a blown transformer. "Down" limit switch incorrect. [. . . ] warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory. This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered with or repaired by a person other than authorized DaLite personnel. Da-Lite's sole obligation under this warranty shall be to repair or to replace (at Da-Lite's option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. [. . . ]