User manual DA-LITE ELECTRICAL SCREEN ARENA ELECTROL

[. . . ] ELECTRICAL SCREEN ARENA ELECTROL Instructions for installation and use WARNING: IT IS IMPORTANT FOR EVERYONE'S SAFETY THAT ALL INSTRUCTIONS ARE FOLLOWED. RETAIN THESE INSTRUCTIONS. Conditions for installation · This screen is intended for interior use. [. . . ] · NOTE: Excessive continuous operation may cause the motor to overheat. If this happens the motor will shut off until it cools to a normal operating temperature. Because the weight of the fabric and the roller tube, nobody must remain under the screen. Unpacking · Check that the screen has not been damaged during transport. If it has been damaged, refuse to accept the parcel or immediately notify the carrier by recorded delivery. · Handle the screen with care to prevent the housing being scratched. Do not lay it down on its side or turn it upside down. · Remove both tube transport clamps (see C). Fixing the screen Fixing the screen to the wall (see A). Fixing the screen to the ceiling (see B). · The screen should be attached firmly using screws of appropriate type and length for the wall or the ceiling (see table for the weight of the screen). · It is essential to check that the fixings are secure. => Note : other mounting modes than the standard brackets can be used (consult your dealer). [. . . ] · If in any doubt, contact your dealer. Maintenance · The mechanical components do not require any maintenance. · If the fabric becomes stained (white plastic fabric only, perforated or non-perforated), use only a small quantity of industrial ethyl alcohol and rub gently with a non-fluffy white cotton cloth (with any other product, there is the risk of leaving a ring or of destroying the grain). DA-LITE reserves the right to modify its products in order to make technical improvements. (cm) 600 650 700 750 800 850 900 (Kg) 305 325 345 365 385 410 430 (cm) 950 1000 1050 1100 1150 1200 (Kg) 450 470 490 510 535 555 A B C 53177A0000 03/2010 1 2 [. . . ]