User manual DA-LITE FAST-FOLD DELUXE

[. . . ] Remove the frame from its case and wrapping. Position it as shown (front view). Two Section Frame Three Section Frame 2. Unfold the frame following the directions given below so that it is lying flat, snap latches will automatically lock. Looking FRom The ToP ToP RoTaTe 90o 1 procedure 3. [. . . ] To fold frame, unlock all four corner braces. Push the blue snap latch buttons and fold the frame. NOTE: for some frames fold the top and bottom first. Leg FRame SPeeDy CRank FRame SPaCeR BLUe SnaP LaTCh BUTTon 2 FoLdING THe pIcTure SurFAce For pAcKING When folding the screen material for packing, observe the following precautions before proceeding: 1. The surface should not be allowed to contact painted, varnished or plastic finished objects for a prolonged period of time. make certain the picture surface is on a clean, flat surface. Then proceed in the following manner: Place clean white tissue paper ­ with no printing ­ on top of the picture surface. if tissue is not available, a soft white cloth or something similar will serve the same purpose. Under no conditions should newspaper or anything similar be used since these may damage the screen material. With the viewing side facing up, fold the fabric in half from top to bottom. make certain when folding, the surface does not come in contact with either the black binding, grommets or snap buttons. if the material on the first fold is more than 3 feet high, then fold once again, but always place clean tissue paper between the folds. For large size screens, fold in half again if necessary. make certain when folding, the surface does not come in contact with either the black binding, grommets or snap buttons. after the top to bottom folding procedure is completed, then fold from left to right and continue folding until the fabric is of sufficient size to fit into the leatherette case. NOTE: keep the screen surface in the envelope provided when it is not in use. Failure to observe these normal precautions may cause discoloration of the material. CLEANING Da-Mat®, Da-Tex®, High Contrast Da-Tex®, Pearlescent, Cinema Vision, Dual Vision, Ultra Wide Angle and 3D Virtual BlackTM surfaces can be cleaned as follows: Using a white clean cloth (100% cotton preferred) that is dampened with clear water, gently wipe the area in one direction. [. . . ] Case optional at additional cost. Presentation Drapery Accessory Kit (ILLUSTRATED) Consists of a set of velour drapes in choice of Blue, gray or Black, Valance, two Wings, Skirt, Valance Bar, and two Wing Bars. · all bars attach to screen frame with slip on clamps. · Valance Bar attaches to frame first. · Valance Bar extends 12" above frame. [. . . ]