User manual DA-LITE MPS-MCM

[. . . ] Tighten the fasteners at the bottom of the Columns. KNOBS TO HOLD POSITION Figure 2 DISCARD J 8. Remove the 1032 Screw and insert the Brass Silencer as shown. PUMP COVER Figure 3 HINGE E 9. [. . . ] % OSHA/ACGIH PEL/TLV No No No No No 9599 <1. 0 <1. 0 <1. 0 <1. 0 None None None None None SECTION III PHYSICAL DATA Specific Gravity (H 0=1): 2 Appearance: Odor: Solubility in Water: Vapor Pressure: Boiling Point: Percent Volatile: Molecular Weight: . 8612 Clear, Green Lubricating Oil Soluble in hydrocarbons, emulsifies in water N/A No data available N/A Variable SECTION IV FIRE PROTECTION INFORMATION Flash Point (C. O. C. ): 199°C, (390°F) Flammable Limits in Air, % by volume: LowerN/A UpperN/A Extinguishing Media: Use dry chemical, foam or carbon dioxide. Unusual Fire and Explosion Conditions: Do not weld, heat or drill containers. Dense smoke may be generated while burning. Carbon monoxide, carbon dioxide and other oxides may be generated as products of combustion. Special Fire Fighting Procedures: Do not enter confined fire space without proper protective equipment. Cool fire exposed containers with water. Caution should be exercised when using water or foam as frothing may occur, especially if sprayed into containers of hot, burning liquid. SECTION V REACTIVITY DATA Stability: Stable. Conditions to Avoid: Heat, open flames, oxidizing materials and mist. Incompatibility: May react strong with oxidizing agents. Hazardous Polymerization: Will not occur. Hazardous Decomposition Products: None (see Unusual Fire and Explosive Conditions in Section IV). SECTION VI PERSONAL HEALTH PROTECTION INFORMATION 3 Threshold limit Value: Eye Protection: 5. 00 mg/m suggested for oil mist. If material is handled such that it could be splashed into eyes, wear plastic face shield or splash proof safety goggles. For prolonged or repeated exposures, use impervious clothing (boots, gloves, aprons, etc. ) over parts of the body subject to exposure. If handling hot material, use insulated protective clothing. Properly dispose of contaminated leather articles, including shoes, which cannot be decontaminated. If vapor or mist is generated when the material is heated or handled, use an organic vapor respirator with a dust and mist filter. All respirators must be NIOSH certified. Do not use compressed oxygen in hydrocarbon atmospheres. Adequate ventilation in accordance with good engineering practices must be provided to maintain concentrations below the specified exposure or flammable limits. [. . . ] Large spills may be picked up using vacuum pumps, shovels, buckets, or other means and placed in drums or suitable containers. Disposal of waste: All disposals must comply with Federal, state and local regulations. Spilled or discarded material may be a regulated waste. If regulated solvents are used to clean up spilled material, the resulting waste mixture may be regulated. [. . . ]