User manual DAELIM S2 BROCHURE

[. . . ] The photographs and drawings shown in this manual may differ from those of actual vehicles due to changes in vehicle specifications and modifications made. This vehicle is designed for 2 riders including the operator. SAFETY PRECAUTIONS Careful driving and the wearing of proper attire and safety equipment are the most important factors in the safe operation of the scooter. Please obey traffic regulations and do not be hurried and careless. Many new vehicle owners operate their newly purchased vehicles with great care and attention to safety factors. [. . . ] (Use type screwdriver. ) (1) Adjust the upper/lower by turning the screw on outside. (2) Adjust the right/left by turning the screw on inside. <TAIL/STOP LIGHT BULB> (1) Loosen 2 tapping screws to disassemble tail light lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly. TAIL/STOP LIGHT BULB : 12V 21/5W CAUTION Lumination angle adjusted incorrectly may dazzle a facing driver's eyes or result in difficulty to show the forward. (7) Replace with new bulb. Apply reverse order of disassembly for assembly. CAUTION When disassembling, care is to be taken for ensuring that a tail light lens can not be damaged. When replacing a tail light lens, be sure to assemble lens seal securely. 29 REAR VIEW MIRROR <WINKER BULB> Front Winker Bulb (1) Loosen tapping screw to disassemble a winker lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly. FRONT WINKER BULB: 12V 10W Rear Winker Bulb (1) Loosen two tapping screws to disassemble a tail light lens and a winker lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly. REAR WINKER BULB: 12V 10W Check the objects at the back are well noticed when seating on a driver's seat, and also mirror for damage or contamination. FUEL LEAK INSPECTION Check there is no gasoline leakage from fuel tank, hoses, carburetor, etc. 30 MAINTENANCE The Required Maintenance Schedule specifies how often you should have your motorcycle served, and what things need attention. It is essential that your motorcycle be served as scheduled to retain its high level of safety, dependability, and emission control performance. Use new, genuine Daelim parts or their equivalent for maintenance and repair. Parts which are not of equivalent quality may impair the safety of your motorcycle and the effective operation of the emission control systems. CAUTION Brake fluid may cause irritation. In case of contact, flush throughly with water and can a doctor if your eyes were exposed. Keep out of reach of children. 34 <REPLENISHING FRONT BRAKE FLUID> Check that the fluid level is above the LOWER level mark with the motorcycle in an upright position. Brake fluid must be added to the reservoir whenever the fluid level begins to reach the LOWER level mark. Clean dust and other foreign materials around reserve tank to prevent foreign materials from falling inside tank. Remove the screws and take oil cup cap, diaphragm plate, diaphragm off. Replenish recommended brake oil to the upper level inside reserve tank. RECOMMENDED BRAKE OIL IS DOT 3 or DOT 4 CAUTION When adding brake fluid, be very careful not to allow foreign materials to enter the reserve tank. Foreign materials can clog the system, causing a reduction or complete loss of braking ability. This can cause brake fluid to leak out of the reserve tank. Do not let brake fluid contact vehicle parts as this damages painted areas. [. . . ] Make sure that you can apply the brake anytime. Always apply the brake when stopping temporarily. Do not drive excessively long distance and take enough break. If any abnormality is found, stop driving and contact service center to inspect the vehicle. [. . . ]