User manual DAEWOO DFT-246

[. . . ] To release ice cubes, twist the ice tray slightly. Ice cubes will be easier to remove if it is held for a short while under running water. Movable refrigerator and freezer shelves Storage shelves should be adjusted depending on the height of the food stored. [. . . ] Do not reinsert the power supply cord within 5 minutes after releasing it from the socket. If not, there may be problems with the compressor. Put food in the refrigerator after running the refrigerator for 2~3 hours. !ICE TRAY @ F SHELF (MOVABLE) # FREEZER TEMPERATURE CONTROL DIAL $ REFRIGERATOR TEMPERATURE CONTROL DIAL % WINDOW ^ R SHELF (MOVABLE) & VEGETABLE CASE COVER * VEGETABLE CASE ( F POCKET ) EGG POCKET 1 EGG CASE 2 UTILITY POCKET 3 JUMBO POCKET 4 BOTTLE POCKET HOW TO INSTALL Location Install the refrigerator in a convenient location away from extreme heat and cold. Allow at least 6cm clearance between the refrigerator and side wall so that the door may open for a fully usable interior and the refrigerator may have good air circulation. The refrigerator is not designed for recessed installation. Keep 6cm of space between the refrigerator and the walls. 1 2 Leave doors ajar for ventilation and dehumidification of both compartments. To turn off the refrigerator With the Refrigerating System in operation, it is likely that the cabinet will feel warm at the front edges and sides. It is due to the hot-line used in this type of Refrigerating System which consists of piping hot gas from the (motor-driven) compressor along the front edges, the sides of the cabinet and the center partition to prevent dewing. This has nothing to do with the storage temperature inside. (The thick line indicates the hot-line) 2. Wipe the outside with a dry cloth, and the inside with a damp cloth. Set the temperature control knob at normal position. Connect the power supply cord. Temperature is controlled by thermostat automatically. The Temperature Control inside the refrigerator controls the degree of cooling for each compartment. 1. TEMPERATURE CONTROL The control has three settings from MIN to MAX. The control has the five settings from 1(Cold) to The MAX mode is available only if atmosphere 5(Coldest). [. . . ] NOTE: During spells of hot, humid weather and in rainy season, moisture may develop on the cabinet, just as water condenses around a cold glass of water. It is not an abnormal condition; wipe off the moisture with a dry cloth. This can also happen when the refrigerator is not installed in an appropriate place. 3 [. . . ]