User manual DAEWOO GSG20IAPC annexe 1

[. . . ] Unscrew top hinge cover with a screw driver. Insert a thin screw driver into the side gap of the cover to remove. 2. Turn top hinge fastener counterclockwise 3~4 times. (Just make it loose ; do not remove. ) Disconnect the harness wires. [. . . ] (Insert the back of hinge to the groove of protrusion first, then front to the top hole of door. ) 3. Turn the fastener clockwise several times. (Do not turn it to the end. ) Adjust the level of door and fasten the top hinge with 2 (left & right) screws. Turn the hinge fastener tightly to the end. Connect harness wirings and screw ground wire. 4. Click and screw the top hinge cover. 5 If refrigerator can not enter a door follow these steps. Replacing Refrigerator Door 1. Put the refrigerator door straight back to the bottom hinge pin. 2. Let the top of door close to the cabinet and insert the top hinge pin to the top hole of freezer door. (Insert the back of hinge to the groove of protrusion first, then front to the top hole of door. ) 3. Turn the fastener clockwise several times. (Do not turn it to the end. ) Adjust the level of door and fasten the top hinge with 2 (left & right) screws. Turn the hinge fastener tightly to the end. Connect harness wirings and screw ground wire. (IH models only) Click and screw the top hinge cover. 6 Leveling & Door Door Adjustment Refrigerator must be level in order to maintain optimal performance and desirable front appearance. (If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced. ) In case freezer door is lower than refrigerator door. . . 1. Insert a screw driver (flat tip) into a groove of the left wheel (bottom of freezer) and turn it clockwise until the door is balanced. (clockwise to raise freezer door ; counterclockwise to lower) · Unless the freezer door is balanced by step 1, then follow the next steps. 2. Open the doors, unscrew and remove the front cover. (The cover is just clicked without screws at initial purchase. ) Leveling & Door 3. Loosen 3 hinge bolts(1 on the left + 2 on the right) a little. (Do not unfasten them completely. ) Insert a hexagonal wrench into the groove of adjusting nut and turn clockwise until the door is level. [. . . ] (Do not remove the fastener. ) Adjustment of freezer door Moving to the right ·· Loosen the left screw(2-2) enough. (Do not remove the screw. ) ·· Turn the right screw(2-1) clockwise, then hinge and top of freezer door moves to the right. ·· Once the gap is adjusted, fasten the left screw (2-2) tightly. Moving to the left ·· Loosen the right screw(2-1) enough. (Do not remove the screw. ) ·· Turn the left screw(2-2) clockwise, then hinge and top of freezer door moves to the left. [. . . ]