User manual DAHON SL-R441 TECHNICAL SERVICE INSTRUCTIONS

[. . . ] lbs. } Note · For smooth operation, use the specified outer casing and bottom bracket cable guide. · Grease the inner cable and the inside of the outer casing before use to ensure that they slide properly. [. . . ] Example: from intermediate chainring to largest chainring. Lever (A) initial position < Rear > To shift from a small sprocket to a larger sprocket To shift one step only, press lever (A) to the 1 position. To shift two steps at one time, Lever (A) initial position press to the 2 position. 1 2 4. After checking that the indicator needle is at the right edge, install the indicator as shown in the illustration. 4. After checking that the indicator needle is at the left edge, install the indicator as shown in the illustration. 1 : Shifts one sprocket E. x. : from 3rd to 4t 43 Technical Service Instructions SI-6FH0C To shift from a large chainring to a smaller chainring When lever (B) is pressed once, there is a shift of one step from a large chainring to a smaller chainring. Example: from largest chainring to intermediate chainring. If it does not operate correctly, re-install the indicator by while taking particular note of steps 3. If it does not operate correctly, re-install the indicator by while taking particular note of steps 3. and 4. Replacement of the shifting lever unit Disassembly and reassembly should only be carried out when replacing the shifting lever unit. Loosen the cable fixing bolt (nut) of the front derailleur, and then pull the inner cable out of the shifting lever unit in the same way as when installing the inner cable. Carry out steps 1 - 2 for replacement of the indicator. Remove the three shifting lever mounting screws, and then remove the shifting lever unit as shown in the illustration. Tightening torque : 0. 5 - 0. 8 N·m {4 - 7 in. lbs. } Replacement of the shifting lever unit Disassembly and reassembly should only be carried out when replacing the shifting lever unit. Loosen the cable fixing bolt (nut) of the rear derailleur, and then pull the inner cable out of the shifting lever unit in the same way as when installing the inner cable. [. . . ] lbs. } Inner cable Inner hole cover Lever (B) This service instruction explains how to use and maintain the Shimano bicycle parts which have been used on your new bicycle. For any questions regarding your bicycle or other matters which are not related to Shimano parts, please contact the place of purchase or the bicycle manufacturer. Attach the same outer end cap to the cut end of the outer casing. These service instructions are printed on recycled paper. One Holland, Irvine, California 92618, U. S. A. [. . . ]