User manual DAHON TIAGRA ST-4500 TECHNICAL SERVICE INSTRUCTIONS

[. . . ] · Read these Technical Service Instructions carefully, and keep them in a safe place for later reference. Operation of rear derailleur lever · Lever F : Shifts from smaller to larger rear sprocket. A A Lever F has a click stop at positions / and ¤. · Lever F : Shifts from larger to smaller rear sprocket. [. . . ] If a round-type handlebar is used, the cable stroke may become too short and this can result in insufficient braking force. Lever F will also move when lever F is operated, but B A be careful not to apply pressure to lever F. Similarly B be careful not to press lever F when operating A lever F. Gears will not shift when both levers are B pressed simultaneously. Be sure to read these service instructions in conjunction with the service instructions for the RD-4500 before use. 2. Pass the inner cable through, and set the outer casing. Be sure leave some excess in the outer casing, even if cutting it to the full length of the handlebars. · SLR outer casing Be sure to leave some excess cable, even if cutting it to the full length of the handlebars. When cutting the outer casing, cut the opposite end to the end with the marking. After cutting the outer casing, make the end round so that the inside of the hole has a uniform diameter. 1. Tilt the lever in (as when shifting) to make it easier to pass the cable through the cable hook. Note: The front lever cannot be tilted to the inside until lever F is pushed b once or twice. Attach the same outer end cap to the cut end of the outer casing. Outer stopper Outer end cap. Inner cable Outer casing Anatomic type Round type ST-4500 Reach adjustment If you would like to reduce the reach, remove the bump rubber and replace it with the accessory pad spacer. (Two types are available: 4° and 8°. ) Pad spacer Technical Service Instructions SI-6LP0A · Rear lever Operation of front derailleur levers (FD-4500 / 4503) · Lever F : Shifts from smaller to larger front chainring. a Pull Tilt Lever F b ST-4500 Shimano Total Integration Operate lever F 8 or more times B to set the lever to the highest position, check on the indicator that the highest position is correct, and then install and adjust the inner cable. Confirm B Lever F Operate at least 8 times Make sure the outer casing is firmly seated in the outer stopper. 2. Pass the inner cable through. Cable hook Lever F a Lever F a Replacement method start position Depress the brake lever, and then pass the inner cable through the cable hole. Inner cable Cable hole Replacing the bracket cover The tabs on the bracket cover each fit to a matching slot on the bracket. If operation of lever a does not complete the chainring shift stroke, operate lever a again for the distance (X') to complete that part of the lever stroke (X) which was short. Full gear shift stroke Actual stroke 1. Apply a thin layer of grease to the two projections of the pad spacer. Press-fit the pad spacer so that the projections go as far in as possible. Pad spacer Bump rubber Inner cable 3. Fix the outer guide to the inner cable, and set the angled member in the bracket. [. . . ] B F : Shifts from smaller to larger chainring. a F : Shifts from larger to smaller chainring. b One Holland, Irvine, California 92618, U. S. A. [. . . ]