User manual DAHON VRO 2010

[. . . ] Obtain and read the service instructions carefully prior to installing the parts. Loose, worn, or damaged parts may cause serious injury to the rider. We strongly recommend only using genuine Shimano replacement parts. [. . . ] We strongly recommend only using genuine Shimano replacement parts. Check that the wheels are fastened securely before riding the bicycle. If the wheels are loose in any way, they may come off the bicycle and serious injury may result. Read these Technical Service Instructions carefully, and keep them in a safe place for later reference. Installation of the CS-S500 sprocket with chain guard guard to of the 1. Install the chainthen installthe right hand dust cap to the hub body, and right hand dust cap B driver. cassette joint the direction of 2. Turn the the illustration pulley inthe red marksthe the arrow in to align on When using the chain tensioner When using the chain tensioner, be sure to read these service instructions in conjunction with the service instructions for the CT-S500 chain tensioner. pulley and the bracket. With the cassette joint in this condition, install it so that the red mark on the cassette joint is aligned with the red mark on the right side of the hub body. Note: When installing a part such as a mudguard stay to the hub axle, install in the order shown in the illustration below. Right hand dust cap B Chain guard Note the direction Should be aligned Pulley Chain tensioner Non-turn washer CJJA LOCK CJ-8S20 8S 20 JAPAN LOCK Right hand dust cap Driver Cassette joint Hub axle Dropout CJ-8S20 JAPAN Mudguard stay Carrier stay Cap nut Align the red marks to install. 2. Align the red marks to install. NOTE: Place the non-turn washers onto the right side and left side of the hub axle. At this time, turn the cassette joint so that the projecting parts of the non-turn washers fit into the grooves of the dropouts. Install the driver cap to the driver on the right side of the hub body. Driver cap Fit the cassette joint bracket securely. Vertical Note the direction 7R Mark Installation of the hub to the frame The method of installing the hub to the frame is the same when the chain tensioner is being used and when it is not being used. The projecting parts should be on the dropouts side. Install the non-turn washers so that the projecting parts is securely in the dropouts grooves on either side of the hub axle. Technical Service Instructions Driver 1. Mount the chain on the sprocket, and then set the hub axle into the dropouts. When not using the chain tensioner Driver cap 7R 3. Take up the slack in the chain and secure the wheel to the frame with the cap nuts. Tightening torque: 30 ­ 45 N·m {260 ­ 390 in. lbs. } 7R 20 8S CJ- N JA PA Be sure to read these service instructions in conjunction with the service instructions for the brake and the shifting lever before use. CJN PA JA Dropout LOCK LOCK Cap nut Hub axle Non-turn washer CJ- JA 8S PA N 20 ring, align the yellow mark with the yellow mark on the cassette joint pulley, and then turn the cassette joint fixing ring 45° clockwise. These service instructions explain how to use and maintain the Shimano bicycle parts which have been used on your new bicycle. For any questions regarding your bicycle or other matters which are not related to Shimano parts, please contact the place of purchase or the bicycle manufacturer. These service instructions are printed on recycled paper. Please note: Specifications are subject to change for improvement without notice. [. . . ] For any questions regarding your bicycle or other matters which are not related to Shimano parts, please contact the place of purchase or the bicycle manufacturer. These service instructions are printed on recycled paper. Please note: Specifications are subject to change for improvement without notice. (English) One Holland, Irvine, California 92618, U. S. A. [. . . ]