User manual DAIHATSU F300 SERVICE MANUAL

[. . . ] BassLink T includes controls to optimize both of these conditions and their adjustment is explained in sections "Controls & Functions" and "Tuning Basslink T" . CHOOSING A MOUNTING LOCATION Choose a mounting location that does not interfere with the seats, seat mechanisms or cargo. BassLink T in a car's trunk. MOUNTING F300 CAUTION: Make sure mounting screws will not puncture wiring harnesses, brake or fuel lines, or the vehicle's fuel tank. Some or all of these may be located behind or under the mounting surface. BassLink T has been designed for easy installation in many vehicle applications. BassLink T should be secured to a solid mounting surface using the supplied mounting hardware. [. . . ] For more system ideas, see your authorized Infinity car audio dealer. BassLink T audio connections for a head unit with two line-level or subwoofer (RCA) outputs. POWER LINE LEVEL INPUT HIGH LEVEL INPUT + L ­ + R ­ AUTO TURN ON GAIN OFF AUTO BASS CROSSOVER BOOST FUSE 25A +BATT REM GND REMOTE LEVEL CONTROL PHASE L R 0° 180° 4 APPLICATIONS (CONTINUED) Figure 9. BassLink T audio connections for a head unit equipped with two speaker-level outputs. POWER LINE LEVEL INPUT HIGH LEVEL INPUT + L ­ + R ­ AUTO TURN ON GAIN OFF AUTO BASS CROSSOVER BOOST FUSE 25A +BATT REM GND REMOTE LEVEL CONTROL PHASE L R 0° 180° 5 INSTALLATION The Remote Level Control may be mounted under the dash or may be dismantled and mounted in the dash for a factory appearance. UNDER-DASH MOUNTING Select a mounting location that allows easy access to the control while driving. Using the Remote Level Control as a template, mark and drill holes in the mounting surface. Attach the Remote Level Control using the mounting screws provided (Figure 10). Under-dash mounting of the Remote Level Control. IN-DASH MOUNTING Disassemble the Remote Level Control by removing the two Phillips-head screws on the front panel, rear panel and on top. Remove the Remote Level Control's bottom and side panels. Slide the Remote Level Control's PC board forward to release the RJ11 connector from the back panel and remove the board along with the potentiometer, knob and connector as a single assembly. Choose a mounting location that allows easy access to the control, and provides 1-3/4" clearance behind the mounting surface. Make sure the head unit is off and its volume control is set to minimum. On BassLink T's top panel, initially set all controls to their midpoint positions, as shown in Figure 13. On BassLink T's top panel, initially set PHASE to 0° . Turn on the head unit and play a favorite music track that has substantial bass. Set the head unit's volume control to 75 percent of the total output (approximately 3 o'clock on rotary controls). Adjust the GAIN control clockwise until the PEAK LED (on BassLink T's top panel) begins to flash with each bass note but doesn't stay lit continuously. Listen to your system, making a mental note of the amount of upper bass being reproduced. Switch the PHASE control to 180° and listen again for upper bass content. There may be more upper bass, less upper bass, or no change at all. The position that provides the most upper bass is correct, but choose either setting according to your taste. Adjust the CROSSOVER control clockwise or counterclockwise until you hear only lowfrequency information. [. . . ] On BassLink T's top panel, slide AUTO TURN-ON to OFF and use the Remote (REM) connection. · PROBLEM: BassLink T's POWER LED remains on after head unit is turned off. CAUSE and SOLUTION: For speaker-level connections, this is normal operation when AUTO TURN-ON is set to ON. BassLink T will remain on another 5 to 10 minutes after sensing that audio signals are not present before shutting down. [. . . ]