User manual DAIKIN FT60BSG

[. . . ] DAIKIN ROOM AIR CONDITIONER MODELS Operation Manual FT50BSG FT60BSG CONTENTS READ BEFORE OPERATION I Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 I Names of Parts G Indoor unit, Opening the front grille . . . . . . . . . . . . . . 5 G Remote controller, Outdoor unit . . . . . . . . . . . . . . . . . . . . 6 I Preparation Before Operation G Remote controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Set the clock at this point. 1 2 3 Choose a place from where the signals reach the unit. Fix the holder to a wall, a pillar, etc. with the screws supplied with the holder. Place the remote controller in the remote controller holder. Remote controller holder Set. ATTENTION About batteries G When replacing the batteries, use batteries of the same type, and replace the two old batteries together. G When the system is not used for a long time, take the batteries out. G When the operation display screen of the remote controller is hard to see and the reception become hard, replace the batteries with new AAA batteries. G The attached batteries are provided for the initial use of the system. The usable period of the batteries may be short depending on the manufactured date of the air conditioner. G To remove, pull it upwards ATTENTION About the remote controller G Never expose the remote controller to direct sunlight. G Dust on the signal transmitter or receiver will reduce the sensitivity. G Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. G If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the shop. 7 Preparation Before Operation Indoor unit I Setting the photo-catalytic deodorizing & air cleaning filter I Setting the clock 1 AM Press . Display AM is displayed. blinks. 1 Open the front grille. G Hold the grille by the tabs on the two sides and lift it until it stops with a click. " G Each pressing of the button advances the mode setting in sequence. The flap automatically swings up and down. To stop the flap at an angle you like, press SWING . . . . . . . . 2 ON/OFF Press . Then OPERATION lamp lights up. Notes on flap angles G When SWING is selected, the flap swinging range depends on the operation mode. (See the figure. ) G The real flap angles are differ from the display of remote controller. DRY · COOL FAN I To stop: ON/OFF Press once again. Then OPERATION lamp goes off. I To change the temperature setting: DRY or FAN mode Press TEMP ATTENTION G Always use a remote controller to adjust the flap angle. If you attempt to move it forcibly with hand when it is swinging, the mechanism may be broken. COOL mode The temperature to raise / lower the temperature. Set to the temperature you like. Adjusting the vertical blade (louvre) I To change the air flow rate setting: Press FAN . COOL or FAN mode Five levels of air flow rate setting The air flow rate setting is not variable. from " " to " " plus " " are Display DRY mode available. Hold the lever and move the louvre. (You will find a lever on the left-side and the right-side blades. ) G At smaller air flow rates, cooling effect is also smaller. ATTENTION G Be careful when adjusting the louvre. [. . . ] G Is there anything to block the air inlet or the outlet of the indoor and the outdoor units?G Is the temperature setting appropriate?G Are the air flow rate and the air direction set appropriately?G Is there anything to block the air inlet or the outlet of the indoor and the outdoor units? [. . . ]