User manual DANBY APAC9036 EFOM

[. . . ] Model · Modèledelo OWNER'S MANUAL MANUEL D'UTILISATION Portable 3 Season Home Comfort The model number can be found on the serial plate located on the back panel of the unit. All repair parts available for purchase or special order when you visit your nearest service depot. To request service and/or the location of the service depot nearest you, call the TOLL FREE NUMBER. When requesting service or ordering parts, always provide the following information: · · · · Product Type Model Number Part Number Part Description APAC9036 For service, contact your nearest service depot or call: 1-800-26-DANBY y (1-800-263-2629) to recommend a depot in your area. Model · Modèle > APAC9036 CAUTION: Read and follow all safety rules and operating instructions before first use of this product. Pour obtenir le service, consultezvotre centre de service le plus rapproché ou composez le : 1-800-26-DANBYnb (1-800-263-2629) qui vous recommandera un centre régional. [. . . ] REMARQUE : Le fonctionnement de vidange directe est prévu pour les applications de tuyau de drainage au plancher seulement. Le fonctionnement de drainage direct ne devrait pas être utilisé en applications de tuyauterie surélevée ou d'évier. DRY (Dehumidifier) Operating Instructions NOTE: During dehumidifier mode, the exhaust hoses do not have to be vented outdoors but should remain attached to the unit. The external water tank must be installed during dehumidifier mode. 1) Press the I/O (on/off) key pad to switch on the unit. 2) Press the MODE key until the DRY symbol (Dehumidifying) appears in the display window. Each depression of the MODE key will advance to a different mode setting (Auto-Cool-Dry-Fan). 3) Press the appropriate (TEMP / TIMER ADJ) key to select a (relative humidity) operating setting between 35% ~ 90% RH (adjustable in increments of 5%) For continuous (non-stop) dehumidifier operation press the (TEMP / TIMER ADJ) key pad until the symbol "- - " appears in the display window. NOTE: The compressor will not cycle off during "continuous" mode. The set relative humidity level will flash in the display window for approximately 5 seconds then automatically revert back to display actual room ambient relative humidity conditions. NOTE: The set operating RH level must be programmed within the 5 second (flashing) condition. To view the "set" relative humidity program any time, press either of the TEMP/TIMER ADJ buttons. NOTE: There is no fan speed adjustment during dehumidifying mode. (the fan speed is factory set for "low") The blue (RUN) indicator light illuminates indicating dehumidifying mode is operational (there may be a slight delay of 10-30 seconds before the cycle begins, this is normal). IMPORTANT: The relative humidity setting selected should always be set a few degrees lower than the room ambient relative humidity conditions, to ensure normal dehumidifying operation. NOTE: it is not recommended to operate your Dehumidifier, below temperatures of 15. 5°C (60°F), this could result in icing-up conditions of the evaporator coils, and minimize efficiency. 4) During `Dry' mode when the external tank is full, the unit will alarm (beep) for 20 seconds and the water full red indicator light will illuminate and the water full icon in the control panel will begin to flash continuously . At this time dehumidification will stop immediately. However, the fan motor will continue to operate (this is normal). Carefully remove the water tank from the cabinet, dispose of the water. Replace the water tank back to it's original position and the Dehumidifying process will automatically resume. It may take 3-5 minutes for the compressor to restart. 5) This unit also has provisions for a continuous "drain" option (for basement applications having a floor drain). The required drain hose is included with this unit. Drain Hose Specifications: Standard garden hose. [. . . ] This warranty is available only to the person to whom the unit was originally sold by Danby or by an authorized distributor of Danby, and is nontransferable. TERMS OF WARRANTY First TwoYears During the first two years (2), any electrical parts of this product found to be defective, including any sealed system units, will be repaired or replaced, at warrantor's option, at no charge to the ORIGINAL purchaser. light bulbs) are not warranted or guaranteed for any length of time. Third Through During the next three years (3) any part of the sealed system found to be defective (consisting of compressor, condenser, Fifth Year evaporator, dryer and all related tubing) will be replaced without charge. [. . . ]