User manual DANBY D2000

[. . . ] Thank you for choosing a Danby appliance to provide you and your family with all of the "Home Comfort" requirements for your home, cottage or office. This Owner's Manual will provide you with valuable information necessary for the proper care and maintenance of your new appliance. If properly maintained, your Danby appliance will give you many years of trouble free operation. Please take a few moments and read the instructions thoroughly and familiarize yourself with all of the operational aspects of this appliance. [. . . ] IMPORTANT: The temperature selected should always be set a few degrees lower than the room ambient temperature, to ensure normal dehumidifying operation. However, it is not recommended to operate your Dehumidifier, below temperatures of 15. The fan motor operates at a pre-set speed, which registers as MED in the LCD window. 4) Condensed water will be accumulated in the water tank. When the tank is full, the unit will sound a signal (8 beeps) and the Water Full indicator light start flashing. At this time the dehumidification process will immediately stop. however , the fan motor will continue to operate (this is normal). Carefully remove the water tank from the cabinet and dispose of the water. Replace the water tank back to it's original position (in cabinet) and the Dehumidifying process will automatically resume. 5) This unit also has provisions for a continuous "drain" option (for basement applications having a floor drain). The "red" light will stop flashing automatically when the water tank has been emptied and/or correctly re-positioned. C) Auto-On & Auto-Off: Pre-select a time that will turn on and turn off the unit (automatically) at specified times (between 0 - 23 hrs, 50 min. This program automatically stores into memory the selected times and will repeat daily, (same specified times) until the program is overridden and/or canceled. Any interruption to the electrical power supply of the unit automatically cancels/erases all auto timed programs. In the event this should happen, you will be required to re-set your program. Before setting the AUTO-ON timer, the TIME OF DAYCLOCK must be set/operational. 2) Select the appropriate MODE under which you want the unit to operate (Cool-Dry-HeatFan). 3) Select the appropriate FAN SPEED setting, under which you want the unit to operate. (Hi, Med, Low) (excluding Dehumidifying, as this mode has "1" fan speed setting only). 4) If you desire oscillation (auto-swing) push the SWING key pad (the "air swing" symbol will be displayed in the display window). 6) To set the AUTO-ON timer, the unit must be turned to the "off" position (non-operational). When the desired time is established, (the time will flash in the display window) press the CLOCK key pad to register the AUTO TIMERON program. [. . . ] 2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this will cause deterioration of electrical components and wiring insulation. The air filter should be cleaned every two (2) weeks. More frequent cleaning may be necessary depending upon indoor air quality. 4) The filter can also be washed in lukewarm soapy water while rubbing it lightly with a brush. [. . . ]