User manual DANBY DAR440BL

[. . . ] · This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes. Safety Alert Definitions Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type: DANGER Danger means that failure to follow this safety statement will result in severe personal injury or death. WARNING Warning means that failure to follow this safety statement could result in serious personal injury, or death. CAUTION Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage. www. U-LineService. com 2 07/2006 1115R and 1115WC Models General Precautions Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: 2 Inspect and Plan You have received a carton containing your 1115R Refrigerator or 1115WC Wine Captain® with a package inside containing a Use and Care Guide and a Product Registration Card. Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference. 1115R units are available in Black vinyl clad cabinets with matching doors and in Stainless models with a stainless steel door and handle, and a black cabinet. [. . . ] Clean out bushing hole in door bottom with a screwdriver if necessary. Hinge 12. Fasten upper hinge to unit (three screws) (Figure 11). Tighten upper and lower hinge screws securely. Replace three plastic plugs removed in Step 10 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side. Plastic Plug Hole Plastic Plug Hole 15. Be sure to place grille cap on opposite side of unit from where it was originally. Screw Right Side Door Swing Right Side Hinge Invert Screw Invert Hinge ULIN_0142_A Other Site Requirements Left Side Door Swing Power Supply The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 10. Figure 9 8. Remove plastic hole plug (Figure 9) from door handle and relocate on opposite side. Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. Environmental Requirements Many U-Line models are designed to operate in harsh outdoor/marine environments. Special considerations include the following: (1115R REFRIGERATOR requirements) · The units are designed to operate between 50°F (10°C) and 110°F (40°C). High ambient temperatures (110°F [40°C] or higher) may reduce the unit's ability to reach low temperatures and may also reduce the ice production rate for those models with icemakers. Do not set door on bottom edge when pushing insert into place. Slide custom door panel insert into 1/4-inch channel in door front. Holding door gasket out of the way, replace handle on door, making sure it is seated properly on insert and that screw holes line up. Install two small screws removed in Step 3. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. Go on to 5 Adjust Door. Wood Trim Finishing The U-Line Wine Captain® is equipped with woodtrimmed wine racks that are coated at the factory with a clear vinyl sealer, which will adequately protect the wood in normal usage. A final finish coat was not applied so that the wood trim could be stained to match décor. The trim on the racks may be coated with a final finish or stained. WARNING To prevent permanent damage to the inner liner of your unit, the wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the product manufacturer's instructions prior to reinstallation. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty. 07/2006 9 www. U-LineService. com 1115R and 1115WC Models If staining the trim is desired, it must be done before the application of any type of final finish. [. . . ] Also make sure the door gasket is not pinched on the hinge side of the door. If the door is properly aligned, go on to 6 Prepare Power Supply. If it is not, use the following procedure. Adjusting Door Alignment 1115R and 1115WC Units 1. Loosen (do not remove) top and bottom hinge screws. [. . . ]