User manual DANBY DPAC10061

[. . . ] x Do not set flower vases or water containers on top of air conditioners. x Do not expose the air conditioner directly to water. x Do not operate the air conditioner with wet hands. x Turn off power source when not using the unit for extended periods. [. . . ] s Wireless Remote Controller-Buttons and Display . s Wired Remote Controller-Buttons and Display . . 2 4 6 7 8 x RECOMMENDATIONS FOR USE s Operating Recommendations . 11 s Bio-Pure Filter Installation (Optional) . 13 x TECHNICAL SPECIFICATIONS E-3 ENGLISH View of the Unit The figures are shown in this instruction may differ from yours depending on the model. Indoor Unit Air flow blades(outlet) Air inlet Air filter(under the grille) Timer indicator Remote control sensor Filter Sign indicator On/Off button On/Off indicator Fan indicator Removing frost indicator (Except Cooling Only Models) E-4 Outdoor Unit TYPE A Air outlet Connection valve Outdoor Unit TYPE B Air outlet Connection valve Outdoor Unit TYPE C Air outlet Connection valve Outdoor Unit TYPE D Air outlet Connection valve Outdoor Unit TYPE E Air outlet Connection valve Note If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall. So clean the heat exchanger with water when it becomes dirty. However, be careful when you wash the surface of the heat exchanger because it is very sharp. E-5 ENGLISH Wireless Remote Controller-Buttons and Display The wireless remote controller is an optional accessory. To use the wireless remote controller, refer to an appropriate manual. Operating mode Temperature setting Mode selection button Temperature adjustment buttons Filter Reset button Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator Fan speed adjustment button Swing button On Timer button Off Timer button On/Off & Timer Set/Cancel button Note - After cleaning the air filter, press the filter reset button. - The heating mode( ) is not selected in cooling only models. E-6 Wired Remote Controller-Buttons and Display ENGLISH Temperature setting Fan speed Air flow direction Filter Sign indicator On/Off & Timer Set/Cancel button On/Off indicator Fan speed adjustment button Swing button Filter Reset button E-7 The wired remote controller is an optional accessory and it is installed on the wall. To use the wired remote controller, refer to an appropriate manual. Operating mode Removing frost indicator (Except Cooling Only Models) Centralized controller indicator (In case of installing the Centralized controller) Communication error indicator On Timer setting Off Timer setting Test indicator Temperature adjustment buttons On Timer button Off Timer button Test button Mode selection button Note - Test button is for your installation specialist. - After cleaning the air filter, press the filter reset button. If you do not check them, the front grille will drop suddenly and you will be hurt. IMPORTANT 2 Remove the front grille. 2-2 Open the front grille about 45° and pull it forward. 3 4 Pull out the air filter. Remove all dust on air filter with a vacuum cleaner or a brush. In case of serious dust accumulation, put the air filter in warm detergent water and shake it vertically. Note When you have installed the Bio-Pure filter, do not allow any liquids to contact the filter. It may lose its properties. 5 6 7 8 Dry the air filter. When you have finished, insert the filter into the front grille. Clean the unit with a vacuum cleaner or a brush once a month. Reinstall the front grille and the safety clips. Note You can use all 4 points of the indoor unit for installing the front grille and the safety clips depending on your requirement. After cleaning the air conditioner, press the Filter Reset button. Note Wired Remote Controller Wireless Remote Controller E-11 Bio-Pure Filter Installation (Optional) The air conditioner can be fitted with a Bio-Pure filter to remove minute dust particles. [. . . ] controller x Check the wireless remote controller batteries. x Check that you are close enough to the remote control sensor. (seven metres/yards or less). Wireless Remote Controller No beep is heard when you x Check that you are pointing the remote controller at the remote control sensor on the indoor unit. press (ON/OFF) on the remote controller x Replace the remote controller batteries if necessary. [. . . ]