User manual DANFOSS TP7000

[. . . ] Turning a programmable room thermostat to a higher setting will not make the room heat up any faster. How quickly the room heats up depends on the design of the heating system, for example, the size of boiler and radiators. Neither does the setting affect how quickly the room cools down. [. . . ] GB F D DAY - Press DAY until correct day is shown (1=Monday, 2=Tuesday etc). 6 Setting the OSC Period, if enabled This display will ONLY appear if the OSC function has been enabled by your installer. Use the + or - buttons to select the OSC period. The choices are 0:30 (30 mins), 1:00 (1 hr), 1:30 and 2:00. 7 Accepting the preset programmes If you are happy to use the preset programmes on page 6, you don’t need to do anything else. To accept these settings just close the front cover and after 2 minutes the pre-settings will automatically be accepted. The unit is now in RUN mode (colon flashes in display) and the heating will operate according to the preset programmes. 8 Before you change the preset programmes Your installer will have set your unit to operate in either 7-day mode or 5/2 day mode. To tell which mode your unit is set press PROG until Event 1 flashes in the display. This unit is in 7-day mode and you can programme different settings for each day of the week (see page 8-9). This unit is in 5/2 day mode and you can enter one of set of programmes for weekdays and another set for weekends (see page 91). 81 Programming in 7-day mode ES DK NL I GR PL LT (separate programmes for each day of the week) a) Press PROG until Event 1 flashes, then press DAY to move from current day to Day 1. B) Amend the time and temperature as follows: i) Use + and – buttons to alter time (press and hold to change in 10 min increments). Repeat steps i, ii & iii above for Events 2, 3, 4, 5 & 6. 1 ii) CZ iii) HR RO iv) c) When all 6 events are correct, press DAY to programme events for Day 2. 8 TP7000 RANGE (If you wish to repeat the previous day’s programme simply press COPY). D) Repeat steps b and c above to programme (or COPY) events for Days 3, 4, 5, 6 & 7. 82 Programming in 5/2 day mode (one set of programmes for weekdays, another for weekends) Press PROG until Event 1 flashes, then press DAY until display shows Day 1-5. [. . . ] 36 TP7000 RANGE (Hvis du ønsker at gentage den foregående dags program , skal du blot trykke på COPY). D) Gentag trin b og c ovenfor for at programmere (eller kopiere) begivenheder for dag 3, 4, 5, 6 og 7. 82 5/2-dages tilstand (et sæt begivenheder for hverdage og et andet sæt for weekender) D ES Tryk på PROG, til Event 1 blinker, og tryk derefter pås DAY, til displayet viser Day 1-5. [. . . ]