User manual DAXTEN AUTOVIEW COMMANDER BROCHURE

[. . . ] AutoView Commander Installer/User Guide Cybex Computer Products International Ltd. Cybex House Shannon Free Zone Shannon, Co. Clare, Ireland (Tel) 00353 61 471 877 (Fax) 00353 61 471 871 www. cybex. ie ©1999 Cybex Computer Products Corporation. IBM, PC, PC/AT and PS/2 are registered trademarks of International Business Machines Corporation. [. . . ] Enter the new channel name or address and press Enter to accept. Press Esc at any point to exit this operation without saving the changes. 17 AutoView Commander Installer/User Guide The ID Window The ID Window appears when you change channels and displays the name of the selected channel. This window can be individually configured for each channel in your system. The characteristics of the ID Window can be changed from the Channel Maintenance Menu. This option is only available if you are operating in non-secure mode or if you are the system administrator. Changing the Size, Colour and Position of the ID Window 1. From the main OSD Window, press the Control key twice or type Alt-M to access the Command Menu. Select `Channel maintenance' from the Command Menu. Choose the option `Options for ID window'. Follow the procedures outlined in the table below to change the size, colour or position of your ID Window. Operation Move the ID Window Procedure Use the arrow keys or mouse to move the ID Window's position on the monitor. If the window flickers but does not move, continue tapping the arrow keys until it moves back into range. Press the <PAGE UP> key to cycle through the available window background colours. Press the <PAGE DOWN> key to cycle through the available text colours. Use the (+) and (-) keys to change the length of the ID Window. Change window background color Change text colour Change window size 4. Press Enter to accept the changes or press Esc to exit the menu without saving the changes. 18 On-Screen Display Operations Setting the ID Window Dwell Time This menu selection lets you set the time that the ID Window remains on screen after a channel switch. Each channel can be configured independently. From the main OSD Window, press the Control key twice or type Alt-M to access the Command Menu. Select `Channel maintenance' from the Command Menu. Choose the option `Dwell time for ID window'. Entering 255 allows the ID Window to stay on screen the entire time the channel is active. 19 AutoView Commander Installer/User Guide Administrator Functions The Administrator Functions Menu is accessed from the Command Menu. Here, you can create an administrator password, set a system logoff time and create individual user logins with specific access and privileges. This menu is only used if you are running your system in secure mode. If you configure an administrator password from this menu, your system will then be in secure mode. [. . . ] If the problem persists, contact Cybex Technical Support. Red status LED illuminated Both amber and green Scan LEDs illuminated Green channel LED not illuminated 34 Appendices Symptom Unable to hot-key switch to a channel Action Verify that no OSD menuing windows are up on your monitor. You must escape from all OSD menus to enable hot-key switching. (No lock symbol on OSD screen. ) Verify that you are in hot-key mode by checking to see if the green status LED is blinking. If it is not, press escape and try going into command mode again. [. . . ]