User manual DAXTEN RP117 BROCHURE

[. . . ] This equipment has been found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. © Copyright 2006. [. . . ] Click Restore Figure 7 ­ Restore factory settings Logging Out To exit the configuration menu, and close the session, click Logout There can only be one Administrator logged into the configuration page at one time. There is a idle time out of 30 minutes, after which the session will terminate. Starting a remote session On a client computer, start Internet Explorer (version 6. 0 and higher) type the Voyager IPs IP address (https://192. 168. 0. 155 default). Enter your username and password on the login page. The screen of the Target Server connected directly to the Voyager IP or the currently selected server on the KVM Switch connected to the Voyager IP appears. The first time you connect you must install the Daxten Certificate and Active X control. You must be logged on as an administrator on the client computer to install the Active X Control. Once the Active X control is installed all user types can login. Figure 8 ­ Remote session window Voyager IP 7 User Guide Full screen mode To work in full screen mode: 1. Ensure that the client computer has the same resolution as the Target Server. Press F11, Internet Explorer window disappears leaving the Explorer toolbar at the top. Right click the Explorer toolbar and check Auto-Hide, the Explorer toolbar disappears leaving you in full screen mode. Press F11, or move the mouse cursor at the top of the screen to display Internet Explorers toolbar and then click restore button. Move the sliders to change the displayed image. Click in the area of the sliders for fine tuning. Figure 11 ­ Manual Video Adjustments the displayed image. Give the key sequence a name in the label box. Press the desired keys, the keys appear in the area provided. From the Special Key Manager Box select the desired key. Press the desired keys, the keys appear in the area provided. Click OK. Synchronising mouse pointers On a client computer, two mouse pointers appear. The Client computers mouse pointer on top of the Target Servers. The two mouse pointers should be synchronised. The following explains what to do if they are not synchronised. [. . . ] Press and hold down the Go Local button for 3-4 seconds while powering up the Voyager IP. Login with the default IP address of the unit: http://192. 168. 0. 155/config. Type username: admin, password: SAFEmode. This username and password will only work after the reset procedure described above. [. . . ]