User manual DAXTEN VISTA NATIVE BROCHURE

[. . . ] VistaNATIVE NATIVE TM PERSONAL KEYBOARD-MONITOR-MOUSE SWITCH INSTALLATION AND OPERATION MANUAL 811 W. Suite 302A, Chicago, IL 60622 Phone: (312) 475-0795 !www. daxten. com LIMITED WARRANTY Daxten warrants the VistaTM to be in good working order for one year from the date of purchase from Dakota Computer Solutions or an authorized dealer. Should this product fail to be in good working order at any time during this one-year warranty period, Dakota Computer Solutions will, at its option, repair or replace the Unit as set forth below. [. . . ] Pressing and releasing <Ctrl> instructs Vista to look for valid commands from the keyboard. You have two seconds between each keystroke to enter a valid command; otherwise Vista aborts the command. NOTE: When entering numeric commands, use only the numeric keys located at the top of your keyboard. Numbers entered from the numeric keypad to the right will not be recognized as valid commands. All command letters are shown capitalized for clarity only. Keyboard computer selection To select a computer from your keyboard, press and release your keyboard's left Control Key (<Ctrl>), then type in the computer number. Remember to use the numbers located at the top of your keyboard. Do not use the numeric keypad. Going to the next or previous computer From the keyboard you can toggle forward or backward through the computers by selecting either the Next or Previous computer. To go to the Next computer, press and release the left Control Key <Ctrl>, then press the "+/=" (plus) key. To go to the Previous computer, press and release <Ctrl>, then press the (minus) key. Use the keys at the top of your keyboard, not those on the numeric pad. Scan mode commands To enable scanning from the keyboard, press and release the left Control Key (<Ctrl>), then type "S". Vista will begin scanning sequentially from its current computer through the remaining computers (as set by the maximum computers command, page 13), then begin again at computer 1. The time between switching to the next computer is the scan time interval and is programmable from 1-15 seconds. To stop scanning, press and release <Ctrl>, then type "X". Entering a computer selection command also disables scanning. The power-on state of scanning can be saved in nonvolatile memory. To do this set the scan state and follow with the Keep command. V I S TA I N S TA L L A TI O N A N D O P E R A TI O N MA N U A L 8 Scan time interval command The scan time interval command sets the time, in seconds, that Vista will pause at each of the computers when scanning. To set another interval, press and release the left Control Key, type "T", enter the new scan time interval (in seconds), and press <Enter>. Remember to use the upper numeric keys, not the numeric keypad to the right. Follow with the Keep command to save the setting. Mode command Vista supports PC keyboard modes 1, 2, and 3. The keyboard mode is set by commands from the CPU. Mode 2 is the most common mode used by the vast majority of CPUs. It is also the power-up state of all PC keyboards. [. . . ] Selects the previous sequential computer. Turns Scan mode on, causing Vista to start scanning sequentially from the current port through the remaining ports and beginning again at Port 1. Note: Scan can also be stopped by entering a Port Selection command. Reset command <Ctrl> R Resets and enables mouse and keyboard, enables PS/2 mouse on currently selected port. [. . . ]