User manual DE DIETRICH DCM399XE1

[. . . ] Si, après le remplacement des lampes halogènes ces dernières ne fonctionnement pas, faire refroidir l'appareil, puis couper l'alimentation pendant quelques secondes. ENGLISH WARNING The distance between the supporting surface for the cooking worktop on the hob and the lower part of the hood must be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account. The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other than electricity (central heating systems, thermosiphons, water-heaters, etc. ). Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct. [. . . ] Remove the grease filters before proceeding with the assembly instructions. This will make the appliance easier to handle. 4: pull the handle outside and unlock the filter. INSTALLATION IN DUCTING VERSION: Before fixing, the outlet pipe for air evacuation to the outside must be installed. Use an outlet pipe with: ­ minimum indispensable length; ­ minimum possible bends (maximum angle of bend: 90°); ­ certified material (according to the State); ­ an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 150 mm). For air evacuation to the outside, follow all the other instructions given on the "Warnings" sheet. Prepare the power supply within the telescopic chimney (for the electrical connection, follow all the other instructions on the "Warnings" sheet). Using the special drilling template, drill the holes for fixing to the ceiling on the vertical side of your hob. Carefully observe all the indications for final positioning of the apparatus. Take into account that one of the template axes must correspond to the axis of the hood controls. Adjust the height of the telescopic structure by means of the four retaining screws C (Fig. 8), taking into account that the height of the hood is 48 mm and that the distance between the hood and the hob must be at least 650 mm (Fig. Insert the air baffle (F) in the structure (Fig. 14). Through the openings E (Fig. 15), fit the flange (G) to the baffle (F) locking it with a turning movement. Fix a flexible pipe to the flange (G) for air evacuation. Take the upper flue (with the slots) and fit it on the telescopic structure with the slots facing upwards; fit the flue to the bracket with 2 screws (Fig. Take the lower flue and fit it in the same manner as before; slide it to the top and stop it in that position using a screw inserted in the hole of the upper flue as a catch (Fig. Take the riduction (L) and assemble it onto the flange (Fig. Fit the hood to the telescopic structure by means of 4 screws (provided) ­ Fig. Fix the air evacuation pipe onto the reduction (L) - Fig. Make the electrical connection by means of the power cable. [. . . ] Remove the screw used as catch and slide the lower flue downwards, placing it gently on the apparatus. Remove the charcoal filter from its case (Fig. Installation is now complete and the grease filters can be reassembled. OPERATION CONTROLS (Fig. Key B : Reduces and increases lighting intensità. [. . . ]