User manual DE DIETRICH DCM5100YE

[. . . ] -- Never use steam or high-pressure devices to clean the oven (electrical safety requirement). SAFETY INSTRUCTIONS -- This oven was designed for use by private individuals in their homes. It is intended solely for cooking foodstuffs. This oven does not contain any asbestos-based components. -- Please make sure children do not play with the appliance. [. . . ] -- Before using your oven for the first time, heat it while empty for approximately 15 minutes. Make sure that the room is sufficiently ventilated. You may notice a particular odour, or a small release of smoke. -- WARNING: accessible parts may become hot when the grill is used. It is advisable to keep children away from the apppliance. 38 1 / NOTICES TO THE USER -- For your safety, your oven is equipped with an AUTOMATIC STOP, if you forget to turn off your oven by mistake. After 23 hours and 30 minutes of continuous use, the AS (Automatic Stop) feature will be activated and your oven will turn itself off. AS or Auto Stop will be displayed instead of the time and a series of successive beeps will be emitted for a short time. Before maintenance or cleaning disconnect the appliance from the mains and wait for it to cool down. The user must not change the appliance supply cable. For replacement contact only a qualified engineer. EN CARING FOR THE ENVIRONMENT -- This appliance's packing materials are recyclable. Recycle them and play a role in protecting the environment by depositing them in local authority containers provided for this purpose. -- Carefully twist the strands together. -- Loosen the screws from the terminal board and remove the power cord to be replaced. -- Insert the power cable through the side of the cover into the cable clip located to the right of the terminal board. -- All the strands of the electrical wires must be secured tightly under the screws. -- The green-yellow coloured earth wire should be connected to the terminal . -- The neutral wire (blue) on the N terminal. -- Screw down tightly the screws on the terminal board and check the connection by pulling on each wire. -- Attach the cable with the cable clip located to the right of the terminal board. -- Close the inspection flap using the two screws. 43 EN 3 / CARING FOR AND CLEANING YOUR APPLIANCE CLEANING THE DOOR Disassembling the door Warning Before removing the door, allow the appliance to cool down. Warning Do not use abrasive cleaning products or hard metallic scrapers for cleaning the oven's glass door, as they could scuff the surface and cause the glass to shatter. 1. Lift the hinge jumpers with your thumb and index fingers, then turn them fully outwards to the end of stroke (Fig. A). Turn the door towards the closure position and lay it on the jumpers: in this way the hinge's spring is blocked. [. . . ] Reassemble the glass cap and reconnect the oven. Tip To unscrew the view port and the light, use a rubber glove, which will make disassembly easier. 45 EN 4 / TROUBLESHOOTING If you have a doubt about the correct functioning of your oven, this does not necessarily mean that there is a malfunction. In any event, check the following points: YOU OBSERVE THAT. . . POSSIBLE CAUSES WHAT SHOULD YOU DO? The oven is not heating. - The oven is not connected to Plug in your oven. Replace the fuse in your electrical - Your fuse is not working. - The selected temperature is Increase the selected temperature. [. . . ]