User manual DE DIETRICH DCV690XE

[. . . ] These products do not contain any asbestos based components. Throughout this manual, indicates safety recommendations, Throughout this manual, The controls on your hood Electronic 3-speed model Fig. 1 GB Lighting Switching off Turning on the hood 1 Low power 2 Medium powerv 3 Max. power The first press on the button will turn on the hood (at speed 1). Each additional press on button button turns the lighting on or off. the same button makes it possible to move up to a higher speed. Pressing on the will turn on the hood (at speed 1). [. . . ] A single press on the In the case of a kitchen heated by a device connected to a chimney (for example a stove) the "recycling" version of the hood should be installed. Do not use the hood without metal filters. Suitable ventilation should be ensured for the room when the suction hood is used at the same time as appliances using gas or another combustible fuel. Installing your hood ? If you possess an outlet to the exterior: fig. 4 Your hood can be connected to this using a flue (minimum Ø 125 mm, enamelled, made from aluminium, flexible or made from a non-flammable material). If your flue is below 125 mm in diameter, you must obligatorily use the "recycling" mode. If you do not possess an outlet to the exterior: fig. 5 All of our appliances can be used in recycling mode. In this case, you should add an active carbon filter which will keep in odours. Assembling your hood The hood must be installed in conformity with the applicable regulations concerning the ventilation of premises. In France, these regulations are detailed in DTU 61. 1 from the CSTB. In particular, the evacuated air must not be channelled into a duct used to evacuate fumes from appliances using gas or other combustible fuels. - Adjust the length of the telescopic chimney by bringing down the lower part and fitting it GB to the top of the hood. To ensure optimal use of your device, we advise that you connect a flue with a diameter of 150 mm (not supplied). Limit the number of angles and bends as far as possible, and keep the length of the flue to a minimum. In the event that the hood will be functioning using exterior evacuation, you should ensure a sufficient inlet of fresh air to avoid a pressure deficiency in the room. Hood to be used in "recycling" mode: fig. 5 and 9 - It is possible to remove the back flow valves. - Fit the plastic smoke deflector to the wall also placing this against the ceiling. Take care to centre the deflector vis-à-vis the vertical line drawn on the wall (fig. 7). - Prepare your chimney taking care to place the vents toward the top to ensure that they are visible (fig. - Fit the upper part to the plastic deflector. - Adjust the length of the telescopic chimney by bringing down the lower part and fitting it into the top of the hood. Changing the lamp ? Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch, Model with halogen lamp: 1. Replace the lamp assembly by carrying out the above operations in reverse order. Cleaning your hood ? The power supply to the hood must be turned off either by removing the plug or by using the circuit breaker switch before you remove the metal filters. After cleaning, the metal filters must be refitted in conformity with the instructions. FILTER CARTRIDGE Remove the protective film before using the filter cartridge for the first time. [. . . ] Replace the lamp assembly by carrying out the above operations in reverse order. Cleaning your hood ? The power supply to the hood must be turned off either by removing the plug or by using the circuit breaker switch before you remove the metal filters. After cleaning, the metal filters must be refitted in conformity with the instructions. FILTER CARTRIDGE Remove the protective film before using the filter cartridge for the first time. ACTIVATED CARBON FILTER For hoods installed "recycling" mode. in MAINTENANCE VITAL EVERY MONTH VITAL EVERY YEAR To avoid all risks of fires. [. . . ]