User manual DE DIETRICH DHB7939X

[. . . ] If you sell or give the appliance to someone else, make sure that you also give them this manual. With a view to constantly improving our products, we reserve the right to make Changes to their technical, functional or aesthetic characteristics in line with technological progress. To easily locate the make, model number, etc. Of your appliance, we recommend that you note this information on the "After-Sales Service Department and Customer Support" page. [. . . ] Evacuation line, whatever its type, must not emerge in a loft space. 1 - USE IN EVACUATION MODE You have a duct that leads outside. Your hood may be connected to it via an evacuation duct (minimum 125mm dia. , made of enamelled, aluminium hose or other non-flammable material). If your duct is less than 125mm in diameter, you must change to recycling mode. 2 - USE IN RECYCLING MODE You do not have a duct leading to the outside. All our appliances can operate in recycling mode. The installation must comply with current regulations for the ventilation of rooms. In particular, air must not be evacuated into a duct used to evacuate fumes from appliances using gas or other fuels. Disused ducts may only be brought into service, if approved by a competent specialist. Energy saving advice To obtain the best performance from your appliance, limit the number of bends and length of the duct as much as possible. It takes 2 people to fit and fasten the hood. Do not remove the cables before the hood is fully installed. The minimum distance between the cooking surface and the lowest part of the hood is 65cm. If the instructions for a hob installed below the hood specify a distance greater than 65 cm, then that distance must be applied. 1 Fitting the ceiling support - Using a plumb line, identify the centre of The hob in relation to the ceiling support. - The notch of the ceiling support (A) must be facing the product. - Fix the ceiling support with the 4 screws 2 Evacuation mode - If your hob is in recycling mode, fix the de- Flector to the ceiling support with the 2 screws provided (M). - Connect the duct to the deflector (recycle mode), or inside an external duct on the ceiling (evacuation mode). - Connect the duct to the deflector (recycle mode), or inside an external duct on the ceiling (evacuation mode). - Slot the end of the duct onto the engine 5 Installing / Fitting the body of the hood - Position your ducts on the product (H). - Take the hood, now fitted with the ducts - Place it under the duct support - Press the upper part (B) to insert the hood Into the duct support - The hood is held in place from the first notch(1st click). [. . . ] Recycle and contribute towards protecting the environment by disposing of packaging in local waste containers designed for this purpose. your appliance also contains a lot of recyclable material. This logo indicates that used appliances must not be mixed with other waste. Appliance recycling organised by your manufacturer is carried out under optimum conditions, in accordance with European Directive 2002/96/EC on the disposal of waste electrical and electronic equipment. [. . . ]