User manual DE DIETRICH DHD309BE1

[. . . ] In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. If your unit features a power lead and plug, position this so the plug is accessible. Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance. USE Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. [. . . ] Attention: you can chose to install the hood with an external motor only if you have bought a hood already planed for this version. INSTALLATION ATTENTION: Two persons are required for proper installation; the unit should be installed by a qualified operator. Remove the grease filters before proceeding with the assembly instructions. This will make the appliance easier to handle. 4: pull the handle outside and unlock the filter. INSTALLATION IN DUCTING VERSION: Before fixing, the outlet pipe for air evacuation to the outside must be installed. Use an outlet pipe with: ­ minimum indispensable length; ­ minimum possible bends (maximum angle of bend: 90°); ­ certified material (according to the State); ­ an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 150 mm). For air evacuation to the outside, follow all the other instructions given on the "Warnings" sheet. Prepare the power supply within the telescopic chimney (for the electrical connection, follow all the other instructions on the "Warnings" sheet). Fixing to the wall: Draw a line on the wall in vertical line with your hob. Mark the first 2 holes to be drilled in the wall, respecting the distances indicated in Fig. ­ Take the air baffle and fit a flexible pipe to it (125 mm diameter) locking it with a metal hose clamp (pipe and clamps are not provided). Fit the air baffle to the upper flue (Fig. - Connect the flexible pipe to the flange on the air vent (Fig. Insert the extension flues setting them on the hood. - Extend the upper flue to the ceiling and secure with the 2 screws H (Fig. INSTALLATION IN VERSION WITH AN EXTERNAL MOTOR: Before fixing the hood the air evacuation pipe running from the hood to the intaking motor should be ready. Use an air evacuation pipe with: ­ minimum indispensable length; ­ minimum possible bends (maximum angle of bend: 90°); ­ certified material (according to the State); ­ an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 150 mm). For air evacuation to the outside, follow all the other instructions given on the "Warnings" sheet. Prepare the power supply within the telescopic flue (for the electrical connection, follow all the other instructions on the "Warnings" sheet). For fixing to the wall refer to the instructions for the ducting version (see point 2, 3), then continue with the instructions below. [. . . ] Also Zero-sets hour metering when the Filter Alarm is active (motor OFF). FILTER ALARM: Displayed for 30" when the motor is off: After 30h of operation, the central segment lights up on the display; It indicates that the grease filters need to be cleaned. After 120h of operation, the central segment flashes on the display; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key E during display of the filter alarm. [. . . ]