User manual DE DIETRICH DHT1119X

[. . . ] Installation La distance minimum entre la superficie de support des récipients sur le dispositif de cuisson et la partie la plus basse de la hotte de cuisine ne doit pas être inférieure à 50cm dans le cas de cuisinières électriques et de 65cm dans le cas de cuisinières à gaz ou mixtes. 18 19 EN INSTRUCTION ON MOUNTING AND USE Cooker Hood 20 Dear valued customer, To discover a De Dietrich product is to experience the range of unique emotions which only high-value items can produce. The attraction is immediate, from the moment you set eyes on the product. The sheer quality of the design shines through thanks to the timeless style and outstanding finishes which make each appliance an elegant and refined little masterpiece in its own right, each in perfect harmony with the others. [. . . ] We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the nonobservance of the instructions included in this manual. Installation Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. This hood is designed for fitting in a cabinet or on some other support. 5) First make sure the wall unit is suitable for the hood according to the dimensions specified in the drawings. Make the necessary holes for the insertion of the electric cable and the exhaust pipe. Make the same holes on the roof of the wall unit. Fixing the brackets to the wall units (Fig. 6-7) Apply the template on the right internal side of the wall unit. The lower and upper edges of the template must coincide with the lower and upper edges of the wall unit (without considering the possible door). Fix bracket R to the wall unit with 2 screws. For proper positioning screw the screws in the smallest holes of the bracket. Carry out the same operation on the left internal side of the wall unit (Bracket L). 8) In the case of wall units deeper than the hood it is possible to install a spacer. The spacer can cover depth differences not bigger than 5 cm Measure the difference between the wall unit depth and the hood depth and remove the excess by a cutter. Fix the spacer on the back of the hood with 3 screws. Remove the front panel, taking away the screws that fix it to the hood. Apply the glass to stop on the support tongues. Reinstall and fix the front panel with the screws. Installing the hood on the wall unit (Fig. [. . . ] To remove the grease filter, pull the spring release handle. The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every four mounths. The charcoal filter may NOT be washed or regenerated. [. . . ]