User manual DE DIETRICH DOD1278X

[. . . ] fig. 1 Set the time by pressing the + or - touch controls (holding your finger on the touch control allows you to scroll through the numbers rapidly) (fig. 2). Example : 12:30 fig. 2 Press the button to confirm. The time display no longer flashes (fig. 3). fig. 3 - To reset the time on the clock Press and hold the button for a few seconds until the display starts flashing (fig. 1), then release. Audible beeps indicate that it is now possible to set the time. [. . . ] - Press the + or - button to set the desired cooking end time. Example : end of cooking at 14:00 (fig. 2). Confirm by pressing the "Start" button. The cooking end time display stops flashing. After these 3 steps, oven heating is delayed so that cooking ends at 14:00. At any time, you can check the cooking time by pressing the button. fig. 2 fig. 1 At the end of cooking (end of programmed time), - the oven turns off; - the cooking time indicator and 0:00 both start to flash (fig. 3), - a series of beeps sounds for a few minutes. The beeping can be stopped by pressing Start. In the case of programmed cooking cycles, the cavity lights up until cooking begins, and remains lit until cooking is finished. fig. 3 29 99644001_A_ml. qxp 21/12/2007 10:36 Page 30 EN 2 / USING YOUR APPLIANCE USING THE TIMER FUNCTION - Your oven's programmer can be used as an independent timer that allows you to count down a time without operating the oven. In this case, the timer display has priority over the clock display. and 0m00s flash in the dis- - Adjust the chosen time by pressing the + ou buttons (fig. 2). fig. 2 - Press the button for a few seconds to turn off the timer. The display stops flashing after a few seconds and the timer starts working, counting down the time in seconds. Once the time has expired, the timer emits a series of beeps to notify you. The beeping can be stopped by pressing on "Start". The display returns to the time of day. Warning It is possible to change or cancel the timer at any time. 30 99644001_A_ml. qxp 21/12/2007 10:37 Page 31 2 / USING YOUR APPLIANCE EN CUSTOMISING THE RECOMMENDED TEMPERATURE Select the cooking function. If you wish to customize the recommended temperature : - Hold down the C button for a few seconds until the temperature figures start to flash. - Turn the + or - button until the desired temperature appears. - For subsequent cooking programmes, the temperature you have just entered will be taken into account. LOCKING THE CONTROLS (CHILD SAFETY) OVEN OFF You have the option of preventing access to the oven controls by taking the following steps: when the oven is off, hold down the + and buttons for a few seconds (fig. 1), a "key" appears on the display -> access to the oven controls is now locked (fig. 2). To unlock access, hold down the + and - buttons for a few seconds. The oven controls are once again accessible. [. . . ] The oven is clean and once again ready for the cooking application of your choice. fig. 4 fig. 5 34 99644001_A_ml. qxp 21/12/2007 10:37 Page 35 4 / CARING FOR AND CLEANING YOUR OVEN EN PERFORM A PYROLYSIS Delayed pyrolysis - Follow the instructions described in the "Instant pyrolysis" section. After validating the pyrolysis cycle with the Start button: - Press the . The end of cooking time flashes to indicate that it is now possible to set it (fig. 1) - Press the + or - button to set the desired end time (fig. 2). [. . . ]