User manual DE DIETRICH DOP 450

[. . . ] Qxd 06/06/05 10:07 Page 24 Table of Contents Introduction What does your oven look like?Description of the appliance Accessories Safety recommendations How do you install your oven?Electrical connection Changing the power cable Useful dimensions for installing your oven How does your oven work?Close-up of your analogue programmer How do you set the clock on the oven? [. . . ] gB a) When supplied with electricity • The displays flashes 12:00. € Program the time by turning the setting button toward + or - (the speed with which the button is turned varies the speed with which the time changes) Example: 12:30. Enter the programme by pressing the selector button. -> The display stops flashing b) Resetting the clock time Press down the button for a few seconds. The time display flashes, indicating that it is now possible to adjust the time. To set the time, turn the button toward + or - so as to advance or turn back the displayed time. After entering the time of your choice, enter it by pushing the button -> the display stops flashing. The time cannot be set if the oven is in delayed cooking mode In the event of a power outage lasting less than 35 hours, when electricity is restored, a message indicates that your oven will automatically readjust the time displayed. How do you program for immediate cooking?The analogue programmer should display only the time; it should not be flashing. € Press and turn the button toward the right to select the cooking mode. When your cooking programme is finished, a three-beep pattern will be emitted for a few minutes. Your oven is equipped with an electronic timer that is independent of the oven functions, making it possible to measure times. In this case, the timer display takes priority over the time of day display. the hourglass appears and 00M00S flashes. Turn the button until you obtain the desired length of time (max 59 minutes and 59 seconds) Enter the time by pressing the button. The display stops flashing and the timer starts working, counting down the time in seconds. When the cooking time is finished, the timer starts beeping to alert you and the hourglass begins flashing. It is possible to change or cancel the timer programme at any time by turning it to 0 and pressing the button to enter. How do you program for energy-saving cooking?* GB The analogue programmer should display only the time; it should not be flashing. Cooking Enter the time by pressing the button. [. . . ] Follow the instructions described in the "Programming for immediate pyrolysis" section, then a) Press the is now possible to set it. B) Adjust the pyrolysis end time by turning the selector button. When the pyrolysis cycle is finished, press the selector button. Touch control, the pyrolysis end time flashes to indicate that it 43 99633803_ML_A. [. . . ]