User manual DE DIETRICH DOP750W

[. . . ] ⷠImmediately call your gas supplier from a neighbor's phone. If you cannot reach your gas supplier, call the fire department. Do not install wall oven beneath the work counter. ⷠThe flue charge shall not be located below the 36" level. [. . . ] (Model with 1½ oven cavity only) Installation Instructions for installing a 1½ cavity oven into an existing 2 cavity opening with dimensions 42 1/8" height by 22 ½" Width. The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. preferred Method Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power supply cord with 3-prong grounding plug If width opening is too wide to secure unit to cabinet with mounting screws, add filler strips. Lower trim (not shown) - overlap cabinet front (at bottom of cutout ¼" minimum. Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly grounded 3prong wall receptacle. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. If an external electrical source is used, the appliance, when installed, must be electrically grounded in accordance with local codes or in their absence of local codes with the National Electric Code ANSI/NFPA No. Check all code rules and regulations for connecting the wall oven to be certain the installation conforms with all local, municipal and state codes as well as local utility regulations. Failure to comply with the above could result in a serious shock hazard. note: All hookups and adjustments shall be performed by qualified technicians. The gas supply line to the unit should be ½" (1. To avoid pilot outage (if applicable) close all openings in the cabinet cavity that encloses this unit. All openings around gas service outlets must be closed at the time of installation. Model With 2 Oven Cavities only iMPORTANT: Refer to the serial plate for information on type of venting , if marked vented , see proper instructions. NOTE: In some areas, outside venting is required or preferred. For specified models with outside venting provided (see specification sheet), use the following instructions for proper installation of outside venting. Remove knockout on the top cover of the unit and bend tab up at right angle to the cover. Hole must be drilled so that holes in pipe and flue collar line up. In order to fasten pipe to flue collar, it will be necessary to move control panel out of the way and reach in to drive screw. Model with 1 ½ oven cavity (see figure 9) Pressure Regulator Shut-Off Valve BEFORE CONNECTING THE UNIT Remove all packing material and literature from wall oven before connecting gas and electrical supply to the appliance. if applicable , remove broiler or storage drawer by pulling drawer out to stops. [. . . ] This keeps the safety valve/ pressure regulator assembly from moving. Using a ½" wrench, turn down the adjustable spud which injects gas into the oven burner. Spud approximately 2½ turns until snug against the LP metering pin. Convert the Pressure Regulator for use with Natural Gas (see figure 11) A. [. . . ]