User manual DE DIETRICH DTE411BL1

[. . . ] -- These cooking hobs are meant to be used exclusively for cooking foodstuffs and preparing beverages and do not contain any asbestos-based materials. -- This appliance is not connected to a combustion by-product disposal system. It must be installed and connected in compliance with all applicable laws. Special care should be given to applicable regulations concerning ventilation. [. . . ] Make the connection directly to the end of the elbow fitted on the appliance. -- Connection with a flexible, wavy metal hose (stainless steel) with screw-on mechanical connectors whose service life is unlimited (Fig. -- Connection with a flexible rubber hose with screw-on mechanical connectors whose service life is 10 years (Fig. B). Warning When connecting your hob's gas supply, if you have to change the direction of the elbow fitted on the appliance: Change the gasket. Screw on the elbow's nut, careful not to exceed a torque of 17 N. m. Q @ ; Q @ ; Fig. B 1 / INSTALLING YOUR APPLIANCE · Gas supplied by tank or cylinder (butane/propane) For your safety, you must choose from the three following connection options: -- Connection with a reinforced copper pipe with screw-on mechanical connectors (compliant with the G1/2 standard). Make the connection directly to the end of the elbow fitted on the appliance. -- Connection with a wavy metal hose (stainless steel) with screw-on mechanical connectors whose service life is unlimited (Fig. -- Connection with a reinforced flexible rubber hose with screw-on mechanical connectors whose service life is 10 years (Fig. 02). In an existing system, a soft pipe fitted with clamps whose service life is five years may be used. It is necessary in this case to use an adaptor without forgetting to fit a sealing washer between the adaptor and the hob's bent (Fig. - Make several attempts to shift from the maximum flow rate to the minimum: the flame should not go out; if it does, unscrew the burner power screw so as to obtain good flame retention during these position switches. Fig. Each burner is controlled by a tap fitted with a safety system that, in the event of accidental flame extinction (spills, draughts, etc. ), quickly and automatically cuts the gas supply and prevents it from being released. Each burner is supplied by a tap that is opened when you press in the knob and turn it in a counterclockwise direction. The "o" point corresponds to a closed tap. -- Select the desired burner by referring to the symbols located near the knobs (e. g. Your hob is fitted with a burner-lighting system built into the knobs. -- To light a burner, press on the knob and turn it in a counterclockwise direction to the maximum setting . -- Continue to press on the knob to produce a series of sparks until the burner lights. The setting for more moderate flame intensities are between the symbol and the symbol. Fig. 01 Tip In order to ensure the proper lighting of the double crown burner, we suggest that you light it before placing cookware on it. When a knob becomes difficult to turn, do not force it. [. . . ] Check the electrical connection of your appliance . Check that the burners are clean and properly assembled. If the hob is attached to the work top, check that the mounting brackets are not deformed. Check that the gaskets under the knobs are not coming out of their lodging. [. . . ]