User manual DE DIETRICH DTE411WL1

[. . . ] Keep these instructions at the place where you can find it easily. If you are unsure of any of the information contained in these instructions, please contact the SamSung customer care center. These instructions are only valid for the countries of destination, the identification symbols of which are indicated on the cover of the instruction manual. The manufacturer shall not be held responsible for any damages to persons or property caused by incorrect installation or use of the appliance. [. . . ] Do not use cookware with a large diameter on the burners near the controls, which when placed on the middle of the burner may touch the controls or be so close to them that they increase the temperature in this area and may cause damage. Never place cookware directly on top of the burner. Do not use excessive weight and do not hit the hob with heavy objects. 260mm 180mm 120mm User can't use cooking pan on the hotplate that overlap its edge. Cleaning and Maintenance Cleaning operations must only be carried out when the appliance is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process. Clean the appliance regularly, preferably after each use. Abrasive cleaners or sharp objects will damage the appliance surface;you should clean it using water and a little washing up liquid. YES Always use cookware that are suitable for each burner, so as to avoid wasting gas and discolouring the cookware. Only use pots, saucepans and frying pans with thick, flat bottom. Always place the cookware right over the burners, not to one side. Usable Soft Clothing Soft Clothing Soft Clothing Nylon Brush Soft Clothing Nylon Brush Nylon Brush Metal Brush Soft Clothing Soft Clothing Metal Brush Metal Brush Soft Clothing Nylon Brush Nylon Brush Nylon Brush Metal Brush Unusable Metal Brush Nylon Brush Metal Brush Metal Brush Acidic/Alkali Detergent Thinner/Benzene Sponge Brush Sponge Brush Sponge Brush Sponge Brush Edible Oil Edible Oil Edible Oil Neutral Detergent neutral Detergent neutral Detergent neutral Detergent Abrasive Abrasive Abrasive Sponge Brush Acidic/Alkali Sponge Brush Detergent Acidic/Alkali Sponge Brush Acidic/Alkali Detergent Detergent Edible Oil Edible Oil Edible Oil Edible Oil Abrasive Acidic/Alkali Detergent Acidic/Alkali Detergent Acidic/Alkali Detergent Thinner/Benzene neutral Detergent neutral Detergent Thinner/Benzene Thinner/Benzene neutral Detergent Abrasive Abrasive Abrasive Thinner/Benzene Thinner/Benzene Thinner/Benzene Pan support, Control handles Take off the pan supports. Badly ignited The middle valve is incompletely opened. Customer Care Centre PO Box 17243 Edinburgh, EH11 4YB United Kingdom Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible. The adjustment conditions for this appliance are stated on the label (or data plate). This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilaton. Before installing, turn off the gas and electricity supply to the appliance. All appliances containing any electrical components must be earthed. Ensure that the gas pipe and electrical cable are installed in such a way that they do not touch any parts of the appliacne which become hot. Gas pipe or connector shouldn't be bent or blocked by any other appliances. Check the dimensions of the appliance as well as the dimensions of the gap to be cut in the kitchen unit. The panels located above the work surface, directly next to the appliance, must be made of non-flammable material. [. . . ] A) You can use a flexible stainless steel pipe available from your after sales service department. Connection using flexible tube with screw-on connectors. (Fig. B) These tubes must not exceed 2 meters in length and must be accessible along their entire length. For the user's safety, we advise the connection to be made with a rigid pipe if this is possible, using a flexible undulated metal tube with scerw-on connectors (maximum length 2meters) (Fig. A) Fig. A Fig. B (A) SEALING STRIP Gas supplied by tank or cylinder (butane/propane) Elbow (C) SCREW (B) BRACKET Fig. A H H Fig. B For an existing installation, where it is not possible to fit a reinforced, braided, flexible gas hose, the connection can be made with a flexible gas hose (maximum length 2meters), Connector with two clamps. [. . . ]