User manual DE DIETRICH DTE414DL1

[. . . ] While an operating cooking zone is very hot, a H lamp or "H" (depending on the models) for this zone, is lit in the indicator. When a cooking zone is in a stop position and its temperature is high this display remains lit. After a prolonged power cut another indicator light may appear; it will go out after any key is pressed. However, the temperature of the radiant cooking zones may remain high. [. . . ] The distance between the edge of your appliance and the side and rear walls (or partitions) must be at least four centimetres (area A). The hob may be inserted directly in the worktop above the oven in the upper position. These hobs must be connected to the mains using a socket in compliance with publication CEI 60083 or an all-pole circuit-breaker device in compliance with the installation rules in force. When power is first supplied to your hob, or after an extended power cut, an indicator light will appear on the control panel. Wait for approximately 30 seconds until this information disappears before using your hob (This display is normal and it is intended, if applicable, for your after-sales service. If the cable is damaged it must be replaced by the manufacturer, its aftersales service or a person with a similar qualification to prevent danger. Preferably use cookware made of: - Stainless steel with a thick or "sandwich" three-metal bottom. The diameter of the bottom of the cookware must be equal to or greater than the printed zone. Do not leave empty cookware on a cooking zone. Do not leave cookware containing hot oil or fat unsupervised on a cooking zone. A higher setting is required if: - there are large quantities - cooking with uncovered cookware - a glass or ceramic pan is used. Remember to unlock your hob before reusing it (see section "using child safety" featutre). When several timers are functioning, the LED or flashing light in the power display indicates the zone or timer which may be modified or turned off. If you forget to turn off a cooking zone your cooking hob has a safety function "Auto-Stop system" which automatically turns off the forgotten cooking zone after a predefined time (between 1 and 10 hours, depending on the power used). if this safety function is activated , the disconnection of the cooking zone is signalled by A A the display "AS"or "A" in the control zone and a beep is emitted for approximately 2 minutes. Simply press any key of the controls to stop it. Your cooking hob has a child safety feature which locks controls which are not in use (for cleaning, for example) or during cooking (to keep your settings). For safety reasons, only the "stop" key is always active and and allows the heating zone to be switched off even if locked. Keep the locking key held down until the LED above it lights up and a beep confirms your operation. When you press the power or timer keys of the zones in operation, the LED of the lock lights up; it will go out after a few seconds, Only the "stop" key is always active In the cooking zones which are not in operation, the symbol and the LED light up when o you press the "on/off" keys. Do not store cleaning products or flammable products in the cabinet underneath your cooking hob. Do not reheat an unopened tin: it might explode. [. . . ] Avoid using cookware with rough or bumpy bottoms: they can capture and transfer particles that may produce stains or scratches on your hob. These faults, which do not prevent operation or unsuitability for use, are not covered by the guarantee. WHAT TO DO Thoroughly moisten the zone to be cleaned with hot water, then wipe off. thoroughly moisten the zone to be cleaned with hot water. [. . . ]