User manual DE DIETRICH DTI708V

[. . . ] The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions Step by step instructions for an operation Hints and Tips Environmental information This appliance complies with the following E. It is very important that this instruction book should be kept safely for future consultation. If the appliance should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know of the functions of the machine and also be aware of the warnings. These instructions are only for the countries stated by the symbol printed on the front cover of this instruction book. [. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. The symbols on the knobs mean: = no gas supply = maximum gas supply = minimum gas supply For easier lighting, proceed before putting a pan on the pan support. Lighting the burners To light a burner, turn the relevant knob anticlockwise to maximum position ( ) and push down the knob to ignite. After lighting the flame, keep the knob pushed down for about 5 seconds. This will allow the "thermocouple" to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. then , check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" and "crown" are in the correct position. In the absence of electricity, ignition can occur without the electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the "maximum" position. To switch off burners To put the flame out, turn the knob to the symbol ( ). 10 electrolux Hobs with cast iron pan supports: after cleaning, place the pan supports back on their position. Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little wasing up liquid has been added. avoid the use of the following: - household detergent and bleaches; - impregnated pads unsuitable for non-stick saucepans; - steel wool pads; - bath/sink stain removers. Should the hob top become heavily soiled, the following products are recommended: - For stainless steel hobs use a proprietary stainless steel cleaner. - For other hobs use Hob Brite or Bar Keepers Friend. The electric ignition is obtained through a ceramic electrode with a metal electrode (Fig - C). Keep these components very clean, to avoid difficult lighting, and check that the burner crown holes (Fig - B) are not obstructed. The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. [. . . ] â· Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply. You can find this label in the package of the injectors supplied with the appliance. Should the feeding gas pressure be different or variable compared with the required pressure, an appropriate pressure adjuster must be fitted on the gas supply pipe, in compliance with the rules in force. With a thin screwdriver, adjust the by-pass screw positioned in the centre of the gas tap control shaft (see Fig. [. . . ]