User manual DE DIETRICH DTV1103X

[. . . ] ß Do not touch any electrical switch. ß Do not use any phone in your building. ß Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. [. . . ] ^ Press down and turn the desired control knob counter-clockwise to the largest flame symbol. ^ While holding down the knob, light the gas at the burner with a match. ^ When the flame appears, keep the control knob pressed in for about 8-10 seconds to allow for the ignition safety control to reach operating temperature. 14 Cleaning and care Grates, Control Knobs Never use scouring agents or pads, abrasive cleaning agents or strong cleaners such as oven sprays, stain or rust removers, as these could damage the surface of the appliance. The surface of the cooktop can be cleaned using a cleaner for ceramic surfaces. Follow the manufacturer's instructions on the packaging. After cleaning, the ceramic surface must be thoroughly dried with a soft cloth to prevent a build up of limescale deposits. Do not use any sharp pointed objects which could damage the seal between the ceramic surface and the surrounding frame or between the frame and the countertop. Under no circumstances use a steam cleaner to clean this cooktop. Pressurized steam could cause permanent damage to the surface and its components, for which the manufacturer cannot accept responsibility. ^ Let the appliance cool to a safe temperature before removing the grates. ^ Clean the grates and knobs with a sponge and a mild solution of warm water and liquid dish soap. Any repairs or maintenance performed by unqualified personnel could be dangerous. ^ Check whether the burners are assembled correctly. ^ Make sure the gas holes in the burner ring are clean and open. Some minor problems can be fixed without a service call. the burners do not ignite after several attempts?Check if: ^ the burners are assembled correctly. ^ the flame holes in the burners are clean and unblocked. ^ the cooktop is plugged in and that the circuit breaker has not tripped. If lack of power is the problem, the cooktop can be lit with a match. See "Using the cooktop during a power failure". ^ Check if there is food residue between the ignitor and the burner. [. . . ] The installation is not proper and complete until the operation of the converted appliance is checked as specified in the instructions supplied with the conversion kit. 33 Converting to another type of gas To convert the burners Turn off the main gas supply (if the appliance has already been installed) and disconnect it from the main electrical power supply before proceeding. The following orifices and needle valves should be installed into their respective burners. Conversion table Code Orifice size (Ø mm) Natural gas (NG) Auxiliary burner Normal burner Fast burner Wok burner inner outer 105 115 150 76 180 1. 05 1. 15 1. 50 0. 76 1. 80 Propane (LP) Auxiliary burner Normal burner Fast burner Wok burner inner outer 68 72 92 37 105 0. 68 0. 72 0. 92 0. 37 1. 05 25 32 40 25 54 0. 25 0. 32 0. 40 0. 25 0. 54 44 52 62 40 88 0. 44 0. 52 0. 62 0. 40 0. 88 Code Needle valve size (Ø mm) Save the orifices and needle valves removed from the appliance for future use. 34 Converting to another type of gas Changing the orifices Auxiliary/Normal/Fast burner Wok burner ^ Remove the pan support, the burner cap, a, and the burner head, b. ^ Using a 7 mm nut driver or socket, unscrew the orifice, c. [. . . ]