User manual DE DIETRICH DTV720J

[. . . ] Stick the foam gasket to the bottom of your appliance. This will allow you to achieve an airtight seal with the worktop. 4 tion ila nt ve Dimensions depending on your model cm spa ce Attach the clips to the hob. (Depending on the model. ) 19 9964-2701_ML. qxp 06/04/2007 16:16 Page 20 EN 1 / INSTALLING YOUR APPLIANCE Connection These hobs must be connected to the mains using a socket in compliance with publication CEI 60083 or an all-pole circuit-breaker device in compliance with the installation rules in force. When power is first supplied to your hob, or after an extended power cut, an indicator light will appear on the control panel. [. . . ] You must unlock your hob before using it. - If you activate the lock while cooking, the stop display will be prioritised on the lock. By pressing the button repeatedly you can highlight and select the cooking zone to which you wish to apply the timer. The LED displays only for the zones that are on. To use the timer: : 1 - Turn on the cooking zone 2 - set the power level. 3 - Position the rotating symbol on this cooking zone. 4 - Set the duration by pressing "+" or "-". When the cooking is finished the zone swit0 ches off, the timer starts flashing "0" and a beep sounds to let you know. The power and timer displays become steady; cooking starts. An indicator in the timer zone shows the burner you have programmed. NOTE: - When the cooking finishes, the display shows 0 and a beep sounds about every 5 seconds for a little while. To cancel these indications, press any touch control for the cooking zone MEMO. - When using MEMO you can return at any time to normal operation (except MEMO) by pressing the touch controls "-", "+" "preselections" to change your setting, or "stop" to stop your cooking. To programme a cooking cycle: 1 - Place your cookware on the cooking zone. 3 - Press briefly the touch control MEMO 4 - Set the power level for the first cycle for the burner you have chosen, for which you want to programme a cooking cycle. Replace an existing cooking cycle program: 5 - Set the zones with extension if necessary; adding or removing extensions will not be taken into account in the other cycles. 6 - Continue cooking; each new setting will be recorded as well as the cooking time. 7 - The dot keeps flashing so long as you keep programming. Confirm and stop the programming by pressing the stop touch control An indicator in the timer zone shows the burner you have programmed. 1 - Place your cookware on the cooking zone. 3 - Press and hold the touch control MEMO Warning When using a zone with extension, you can choose the zone only when setting the first cycle. 4- Set the power level for the first cycle for the burner you have chosen, for which you want to programme a cooking cycle. Each new power level setting is then saved as well as how long it will run for. The dot flashes while you are programming. Confirm and stop the programming by pressing the stop touch control 26 9964-2701_ML. qxp 06/04/2007 16:17 Page 27 2 / USING YOUR APPLIANCE EN Safety while using Residual heat H After a long cooking period, the zone used can remain hot for several minutes. An`'H'' flashes during this period. [. . . ] See the "Electrical Connection" section. On switching on YOU OBSERVE THAT: The hob does not operate and the indicator lights on the control panel do not light up. The hob does not function, the information is displayed. POSSIBLE CAUSES: The machine is not connected to the power source. The power source or connection is defective. The hob is locked WHAT SHOULD YOU DO? Inspect the electrical circuit breaker and fuses. [. . . ]