User manual DE DIETRICH DWD1114B

[. . . ] De Dietrich You can find a full range of information about the brand at www. Com Visit the De Dietrich Gallery, 6 rue de la Pépinière (Paris eighth district) Open from Tuesday to Saturday from 10 am to 7 pm 12 INDEX 1 / PROTECTION OF THE ENVIRONMENT 2 / DESCRIPTION OF WARMING DRAWER 3 / SAFETY TIPS 4 / INSTALLATION 5 / ENCASEMENT 6 / USING YOUR WARMING DRAWER 7 / CLEANING AND MAINTENANCE 8 / AFTER SALES SERVICE 13 14 15 16 17 18 21 21 1 / PROTECTION OF THE ENVIRONNEMENT The packaging materials used for this appliance can be recycled. Take part in recycling and help protect the environment by discarding them in the appropriate waste bins provided by the municipal authorities. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] 15 4 / INSTALLATION Before connecting the appliance to the power supply, check that the wires of your electric installation have sufficient diameter to supply power to the appliance normally. The fuse for the installation shouldbe 10 amps. It is necessary to provide a bipolar cut-off device in the power supply circuit, where the opening of the contacts is more than 3 mm. The electric connection should be done before the appliance is set in the cabinet. The drawer should be connected by a (standard) power cord with three 1 mm² couplers (1 single phase + 1 N + ground) to the 220-240 V single phase power supply via an electric circuit corresponding to the standard CEI 60083 or complying with the installation rules. The protective wire (green/yellow) corresponds to ground on the appliance and should be connected to the ground of the installation. In the case of a connection via an electric outlet, the outlet should be accessible after the installation of the appliance. The neutral on the heating drawer (blue wire) should be connected to neutral on the power supply. WARNING : If the warming drawer malfunctions in any way, unplug the appliance or remove the fuse corresponding to the sector where the warming drawer is hooked up. 16 5 / ENCASEMENT Sommaire Set the appliance into the niche in the cabinet. Make certain that the body of the appliance is positioned correctly. Open the drawer and fasten the appliance to the sides of the cabinet with 2 screws and the 2 spacers delivered with the appliance. DWD1114/94 DWD1129 17 6 / USING YOUR WARMING DRAWER INFORMATION BEFORE USE The appliance should be used exclusively to preheat crockery. The appliance uses a hot air system to heat the dishes. A fan distributes the heat from the resistor in the drawer. The dishes are heated rapidly and uniformly by circulation of hot air. A protective grid prevents the dishes from coming into contact with the resistor or the fan. The floor of the drawer is covered with an antiskid mat that prevents the dishes from sliding when the drawer is opened. [. . . ] Use a special non-abrasive cleanser for stainless steel. The antiskid mat can be removed to clean the bottom of the drawer. The antiskid mat can be washed with warm water and detergent. Then dry it off and put it back in the drawer when it is completely dry. [. . . ]