User manual DE DIETRICH DWSL980X

[. . . ] On the cutting edge of innovation, Thomson contribution to the improvement of your everyday quality of life lies in bringing you products that are ever more impressive, simple to use, respectful of the environment, aesthetic and reliable. Please read this guide to installation and use of your appliance carefully before turning it on. This will allow you to become familiar with its operation quickly. 1 How to carry out your initial installation · Putting your wine cellar into service . [. . . ] 6- Fit the plinth end into the space provided for the hinge bracket. How to carry out your initial installation Your appliance is delivered with the door opening from left to right (hinges on right). You can, if you wish, reverse the door opening: 1- Unscrew the upper hinge, unhinge and remove the door. 2- Remove the lower right hinge pin and unscrew its support . 4- Screw the support to the left side of the door and replace the hinge pin. How to carry out your initial installation 5- Fit the plinth end into the space provided for the hinge bracket. 7- Reposition the door on the lower hinge pin, put the upper hinge in place and screw on. Remove the screws and block the holes with the plugs supplied with these instructions. 4 Refit the handle with the two screws, and replace the screw covers. If necessary, you can adjust the alignment of the door and the wine cellar control panel. Proceed in the following manner: 1- Open the door so that it does not impede your view. - Always make sure your circuit is earthed. - If you have to change the supply lead, we recommend that you exchange it for a lead of the same type. You can get this from our after-sales service Your appliance is compliant with European Directives CEE/73/23 (low voltage directive), CEE/89/336 (electromagnetic compatibility) and CEE/96/57 (energy efficiency) as well as their modifications. Putting your wine cellar into service Indicator light (Orange light) Low humidity indicator light (Yellow light) Temperature indication light s (Green light s) Temperature control knob Lock ting in safety mode, guaranteeing the maintenance of your wine at the conservation temperature. In this case, please refer to the paragraph "Operational anomalies" Humidity alarm indicator light (2) - This light comes on when the ambient humidity rate in your wine cellar is too low. - To maintain the required level of humidity, you need to add water to the hydrating tray, situated at the bottom of the unit. Hydrating tray - The role of the hydrating tray is to keep water at a level that will maintain a high enough humidity rate in the appliance and ensure that your wine is correctly preserved -If the humidity alarm light (2) comes on whilst you are putting the unit into service or during operation, add some water to the tray. Door lock (5) - The lock fitted to your wine cellar guarantees the protection of your wines. - To operate the lock it is necessary to push and turn the key. Putting your appliance into service - Connect to the electricity supply. - Set the thermostat knob to a medium position in the ageing zone, 11° to 14° (4) - The orange safety light (1) should be on. [. . . ] The bottles used for the tests are of the Bordeaux type: 290 mm tall, 76, 5 mm in diameter (type: syndical, lightweight, medium, optima) In the version fitted with wire racks, the material is flexible. Depending on the method used to fill the rack, it can bend. This has however no negative impact on the storage of your bottles of wine. The maximum load varies depending on the type of racks used: Wire racks: 55 bottles Wooden racks: 50 bottles 32 The label located on the top of the appliance 50 shows the maximum weight that may be placed on the shelf. [. . . ]