User manual DE DIETRICH QUICK GLASTEST BROCHURE

[. . . ] We wanted to offer you a product of excellence. In the DE DIETRICH product line, you will also find a wide range of ovens, microwaves, hobs, cookers, dishwashers and fridges that you can coordinate with your new DE DIETRICH hood. Of course, in an ongoing effort to best satisfy your demands with regard to our products, our after-sales service department is at your disposal and ready to listen in order to respond to all of your questions and suggestions (contact information at the end of this booklet). Com, where you will find our latest innovations as well as useful and complementary information. [. . . ] - If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. - If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, ventilation shaft, etc. ) or to a CMV (controlled mechanical ventilation) system. - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking hob. USING THE EVACUATION MODE If you possess an outlet to the exterior (fig. 1) Your hood can be connected to this outlet using a flue (minimum diameter 125 mm enamelled, or made of aluminium, flexible or fireproof material). If your flue is less than 125 mm in diameter, you must use the recycling configuration. USING THE RECYCLING MODE If you do not possess an outlet to the exterior (fig. 2) All of our appliances can be used in recycling mode. In this case, you should add an active carbon filter which will keep in odours. The size of these cut-outs allows you to adjust the position to the right or left. aB E x2 B F B C A > 70 cm D = = fig. 1 H G Tip Correct the height and the levelness by moving the adjustment screws "G", then firmly press the hood by tightening the screws "H". 1), attach the metal ventilation shaft bracket against the wall, flush with the ceiling for support. -- Mount the back-flow valve near the motor outlet (fig. This back-flow valve makes it possible to block the entry of air from the outside. -- If a 125-mm flue is being installed, use the adapter provided (fig. If the diameter of your exterior flue is less than 125 mm, you must connect your hood in the recycling configuration. -- Slide the end of the flue over the motor outlet (fig. -- Prepare your telescoping ventilation shaft, taking care not to block the vents (fig. Fit the ventilation shafts into one another as far as they will go. [. . . ] Keep your finger pressed at the same time on and . To configure it for recirculation mode, press to see the and buttons light up. EXTRACTION MODE If your hood is connected to an external outlet, you can configure it for extraction mode: Press and simultaneously. When Press and are lit: your hood is configured for EXTRACTION. [. . . ]