User manual DEFINITIVE TECHNOLOGY XTR-20BP V1.1

[. . . ] Two XTR-20BP bipolar speakers are being used for surround left and right channels behind the listener. All four XTR models are utilized above to achieve an ideal 7. Standing to the left and right of the LED TV are XTR-50s and sitting atop the equipment table is an XTR-60 serving as the center channel. Two XTR-40 speakers play surround left and right while two XTR-20BP bipolar speakers are being used for surround back channel. [. . . ] Fish wire thru leg before making connection. *NOTE* XTR-60 and XTR-50 only The vertical table-stand is supplied with only the XTR-60 and XTR-50 models. With your stand securely fixed to the back of the speaker attach the speaker wire connector (page 12), then insert connector to speaker's terminal. After the stand has been securely fastened to the speaker and all connections made, position the speaker on the table or shelf. The Mythos XTR series was designed to hang next to your thin wall-mounted television. A bracket has been supplied to secure your Mythos XTR loudspeaker to make wall mounting easier. Two cardboard mounting templates are provided; one for horizontal orientation and the other is for vertical mounting. Temporarily fix the template in the intended location with tape or pins. Use a bubble level to make sure the template is level or plumb. Drill screw holes in wall pre-drill the pilot-hole locations for mounting screws (not included). Use screws rated to hold securely in the wall material and have screw heads at least 0. *NOTE* Measure twice - Make sure the speaker clears the ceiling, adjacent walls, corners, beams, lighting fixtures and door/window frames. Leave at least 1" (25 mm) above or to the side of the speaker location to allow the speaker to slide onto the screws. Make sure the center of the template is centered with the TV screen's center points. It is best if at least one screw hits a wall stud. If there is no stud behind the pilot-hole location, install wall anchors (not included) to secure the bracket screws. Firmly push the wire connector into the female receptacle on the back of the speaker. Line up the speaker so that the screws enter the center part of the + shaped channels; slide the speaker down so that the screw heads hold the speaker in place. It is possible to wall mount a XTR loudspeaker without the supplied bracket. Simply procure the appropriate screws for your installation to carry the speaker weight and follow these steps. Two cardboard mounting templates are provided; one for horizontal orientation and the other is for vertical mounting. Temporarily fix the template in the intended location with tape or pins. [. . . ] Definitive makes no warranty with respect to its products purchased from dealers or outlets other than Definitive Technology Authorized Dealer. The warranty is automatically void if: 1) The product has been damaged, altered in anyway, mishandled during transportation, or tampered with. 2) The product is damaged due to accident, fire, flood, unreasonable use, misuse, abuse, customer applied cleaners, failure to observe manufacturers warnings, neglect or related events. 3) Repair or modification of the Product has not been made or authorized by Definitive Technology. [. . . ]