User manual DEI AUTOMATE 410 Owners Guide

[. . . ] Model 410 Owner's Guide Limited Lifetime Consumer Warranty Directed Electronics, Inc. ("DEI®") promises to the original purchaser to repair or replace with a comparable reconditioned model any of the purchased brand unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally installed and serviced by an authorized DEI dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized DEI dealer; and the unit is returned to DEI, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. This warranty is non-transferable and is automatically void if: the original purchaser has not completed the warranty card and mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date code or serial number is defaced, missing or altered; the unit has been modified or used in a manner contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or construction. [. . . ] If the system is pro- 6 © 1999 Directed Electronics, Inc. grammed for passive mode, it will automatically activate the Failsafe® Starter Kill relay 30 seconds after the ignition is turned off. Passive mode is indicated by rapid flashing of the LED after the ignition is turned off. NOTE: For passive mode to be effective, the Failsafe® Starter Kill relay must be installed. If passive mode is programmed on, it is also possible to program the system to lock the doors automatically. If passive locking is turned on, care must be taken to prevent the keys from being locked in the vehicle. Disarming/Unlocking To disarm the security system and unlock the doors of the vehicle, press for one second. The Failsafe® Starter Kill will be deactivated and the vehicle's horn (if connected) will honk twice. The parking lights will also flash twice (if connected). The red status LED will go out, unless the system is programmed for passive mode. To exit Valet Mode, repeat the steps above. The LED will turn off when exiting Valet Mode. Panic Mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter!Just press and you will enter Panic Mode. The horn will honk and , , or on the transmitter. the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press NOTE: In order for Panic Mode to function, the vehicle's horn (or optional siren) as well as the vehicle's parking lights must be connected. Rapid Resume Logic The system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. If the unit is in Valet® Mode and the battery is disconnected for any reason, such as servicing the car, when it is reconnected the unit will still be in Valet Mode. This applies to all states including arm, disarm, and Valet Mode. © 1999 Directed Electronics, Inc. 9 Programming Options Programming options control what your system does during normal operation, and require little or no additional parts. However, some may require additional installation labor. The following is a list of program settings, with the factory settings in Bold: s Passive mode or active mode. In passive mode the Failsafe Starter Kill relay will be automatically activated 30 seconds after the ignition key is turned off. s Both the ignition switch-controlled door lock and unlock features can be turned on or off. If ignition door lock is on, the vehicle's door will lock three seconds after the key is turned on. If ignition door unlock is on, the vehicle's doors will unlock when the key is turned off. [. . . ] Failsafe® Starter Kill: An automatic switch controlled by the security system that prevents the starter from cranking whenever the system is armed. The vehicle is never prevented from cranking when the system is disarmed, in Valet® mode, or should the starter kill switch itself fail. Your system is ready for this feature, however installation of this feature may require additional labor. LED: Red light mounted somewhere in the vehicle. [. . . ]