User manual DEI ORION RGC-1

[. . . ] Used on the first amplifier in a daisy-chain, it works as a remote pre-amp volume control. Warning: The RGC-1 can be used only on ORION amplifiers that have a 1/8-inch mini-jack remote gain port on the connection panel. Using the RGC-1 with other ORION products will damage the system. OPERATION The RCG-1 is shipped in its retracted position. [. . . ] Find a suitable location which will not interfere with driving that is easy to reach. Mount the bracket in place using the 2 screws and secure the RGC-1 to the bracket as shown below. ©2004 Directed Electronics, Inc. 1 AC502 Nut Under Dash Mounting Bracket Label Nut Knob Screws In-Dash Mounting Note: There must be enough clearance behind the dash-panel before selecting the location to mount the RGC-1. A 1/2-inch hole must be drilled to mount the RGC-1 in the dash panel. Side in the control from the rear of the dash panel and place the trim label on the threaded shaft. Secure the control with the nut and mount the knob If there is no access to the back of the dash panel, drill a 3/4-inch hole in order to pass the entire RGC-1 through the hole from the front of the dash panel. Once the control is through the hole, the clip shown below is passed through the hole and slid around the threaded shaft of the control. Place the trim label on the threaded shaft and secure the control with the nut and mount the knob. AC502 Front Mount Nut Clip Dashboard Trim Panel Label Nut Knob AC502 Nut Dashboard Label Nut Rear Mount Knob 2 ©2004 Directed Electronics, Inc. ADJUSTMENT PROCEDURE 1. Set the gain controls of the amplifier according to the "Adjusting the Sound of Your System" in your owner's manual. The amplifier primary gain controls determine the maximum allowed output level that the amplifier. Set the control knob of the RGC-1 to its mid-rotation position. Check the output level of the subwoofer. The amount of bass can be adjusted for the type of music and individual preference. Warning: DO NOT increase the amplifier gain without repeating Step 1. Failure to do so may damage your amplifier and speakers. This will void your warranty. ©2004 Directed Electronics, Inc. 3 Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. [. . . ] Unit must be returned to Directed, postage pre-paid, with: consumer's name, telephone number, and address, authorized dealer's name and address, and product description. IN ORDER FOR THIS WARRANTY TO BE VALID, YOUR UNIT MUST BE SHIPPED WITH PROOF OF INSTALLATION BY AN AUTHORIZED DIRECTED DEALER. ALL UNITS RECEIVED BY DIRECTED FOR WARRANTY REPAIR WITHOUT PROOF OF DIRECTED DEALER INSTALLATION WILL BE COVERED BY THE LIMITED 1 YEAR PARTS AND LABOR WARRANTY. [. . . ]