User manual DELONGHI CC 80 IU

[. . . ] ⷠThis appliance is for household use only. The container is designed for use with this appliance. Do not set a hot container on a wet or cold surface. Do not use a cracked container or a container having a loose or weakened handle. [. . . ] It is entirely normal for the machine to emit steam during the coffee percolating or for a few drops of condensation to form around the lid. By leaving the "coffee" switch pressed after brewing, the hotplate (S) will keep the coffee in the carafe at just the right hot temperature. Fill the measuring jug (Z1) with water up to the 170 g ­ 6 oz line (fig. Pour it slowly into the boiler, first making sure that the "cappuccino" switch is off and that the steam knob is turned off (fig. When it is filled like this the boiler provides enough water for between 15 and 20 cappuccinos. ⷠWarning: if the boiler is filled while it is hot (for example when the water runs out while a cappuccino is being made) pour in only the amount of water shown above and NEVER TRY TO FILL THE BOILER UP TO THE MAX 170 g ­ 6 oz MARK (fig. 8) otherwise the milk will not froth properly. ⷠNext close the boiler cap by turning it firmly in a clockwise direction. Note: for safety reasons it is not possible to unscrew the boiler cap while the boiler is hot as it turns without unscrewing; if you need to fill the boiler you should wait until the water contained in it has been completely used up or until the boiler has cooled down. Further Boiler Refills Further boiler refills must be carried out as described in the previous paragraph and ONLY when the water in the boiler has completely run out. preparing the Milk for Cups of Cappuccino · Before dispensing milk, the boiler must be preheated for 10 minutes. Therefore, press the "CAPPUCCINO" button before preparing coffee; doing so, the boiler will heat right up. ⷠPrepare the coffee as illustrated in the paragraph headed "PREPARING THE COFFEE" and pour about 2 fl. To make a cappuccino, pour into the tank milk which is neither boiling nor hot. With the tank filled to the "MAX" line, 2 or 3 cappuccinos can be made. Never exceed the little mark which is placed immediately above the word "MAX" (fig. 10) or the milk may continue to drip from the pipe after the cappuccino has been prepared. ⷠPlace the cup containing coffee under the milk tank pipe, check that the milk tank is firmly attached, wait for the "OK" pilot lamp (N) to come on, the turn the steam knob at leat a full turn counter-clockwise. The "frothed" milk will begin to trickle out of the milk tank pipe (fig. To avoid the milk splashing if small cups are used, the anti-spray hood should be fitted on the milk tank pipe (fig. Fill the cup with the desired amount of frothed milk. To ensure that the milk froths properly, always close the steam knob and wait for the OK pilot lamp to come on between one cappuccino and the next. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. If repairs become necessary or spare parts are needed, plase write to: De'Longhi America Inc. 800-322-3848 The above warranty is in lieu of all other express warranties and representations; All implied warranties are limited to the applicable warranty period set forth above. This limitation does apply if you enter into an extended warranty with De'Longhi. [. . . ]