User manual DELONGHI CORDLESS METAL KETTLE KBX3020

[. . . ] · Remove the plug from the mains socket when not in use and before cleaning. Allow the kettle to cool before cleaning. · Remove the kettle from its power base before filling. · Never move the kettle whilst it is in use. [. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. Only 13amp replacement fuses which are ASTA approved to B. S. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. WARNING - THIS APPLIANCE MUST BE EARTHED Green and Yellow to Earth Blue to Neutral yy , , yy , , yy , , 4 13 amp Fuse Brown to Live Cord Clamp KBX 3020 GB 30-10-2001 15:19 Pagina 5 BEFORE USE · Remove all packaging from the kettle and power base. · Remove any labels from the outer stainless steel surfaces. · Remove the filter by pushing as shown in fig. "Removing the scale filter" · Fill the kettle and boil. · The boiled water should be discarded and the kettle rinsed out with cold water. This procedure should be carried out three times, to remove any manufacturing dust, etc. · After the kettle has been rinsed out, re-fit the filter (fig. 3). 1 IN USE Power base with 360° access 2 3 With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. · Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. · Do not leave loose cord hanging over the edge of work surfaces. CORD EXIT 4 Filling · Remove the kettle from the base unit before filling. · Open lid and fill kettle to desired level. Do not fill with less than 0, 25 litre of water to prevent the kettle running dry while operating; misuse of this kind will shorten the life of the element. Do not fill with more than 1, 7 litres of water (up to the MAX indication located inside the kettle) (fig. If the kettle is overfilled, there is a risk that boiling water may be ejected causing burns. MAX 1. 7 litres MIN 0. 25 litres 5 5 KBX 3020 GB 30-10-2001 15:19 Pagina 6 Switching on · · · · · Plug the power base into the mains socket. 0 The kettle will automatically switch off once the water is boiled I (the ON/OFF switch will click upwards and the lights will go out). [. . . ] · Rinse under a tap whilst brushing with a soft brush (fig. 3). To clean the scale filter It is vital to clean and descale regularly in order to maintain good working order · Use a proprietary descaling product e. g. We recommend using citric acid crystals as follows: · Pour into kettle about 50 gr. of citric acid cristal and then fill with water up to the max level indicated and then boil. [. . . ]