User manual DELONGHI DC 300DIGI T

[. . . ] If the appliance requires repair, contact an authorised technical service centre only and ask for original spare parts to be used. Failure to respect the above could reduce the safety of the appliance. · The power cable of this appliance must never be replaced by the user as it requires the use of special tools. If the cable is damaged or requires replacing, contact an authorised service centre only to avoid all risks. [. . . ] After 5 seconds, the display will stop flashing and the programmed time will be memorised; PREPARING THE COFFEE · Fill the carafe with cold water to the level of the graduations corresponding to the number of cups of coffee to be prepared (fig. IMPORTANT: never exceed the 10 cups line to avoid water leaking from the slits in the back of the appliance. Do not use hot water or the appliance will indicate the end of coffee perco13 lation too soon. · Pour the water into the water tank (fig. 4). The quantity of coffee obtained after percolation is slightly less than the water poured into the tank as a certain amount of water remains in the coffee grounds or is lost as steam. · Place the carafe on the hot plate, making sure the lid is in place. · Place the coffee in the filter, using the measure provided. As a general rule, use a level measure of coffee (about 7 grams) for each cup required (for example, 10 measures for 10 cups). However, the quantity of coffee used can be varied according to personal taste. Use good quality coffee for filter coffee machines. 6) comes on and the appliance starts to make the coffee. (To make the coffee at the programmed time, press the AUTO button and the AUTO indicator light comes on). Delivery of coffee will start after a few seconds. At the end, four beeps will indicate that the coffee is ready. During percolation, it is normal for the appliance to give off steam and for condensation to form near the lid. To keep the coffee hot after percolation, place the carafe on the hot plate and leave the appliance on (coffee ON indicator lit): The coffee in the carafe is kept at the right temperature. completely vent the steam by keeping the steam knob open (fig. Important: the boiler should ideally be filled when cold using the measure provided. If the boiler must be filled when hot (for example, when the water runs out while you are making cappuccino), you are recommended to add one measure only and NOT TO FILL THE BOILER UP TO THE MAX 170 g ­ 6 oz mark (fig. 7) otherwise the next time you use the appliance the milk will not be perfect frothed. Filling the boiler with water subsequently · When you fill the boiler subsequently, follow the instructions given in the previous paragraph. Fill ONLY when the water in the boiler is complete exhausted. Preparing the coffee for making cappuccino · Firstly press the "cappuccino" switch (fig. [. . . ] 14). Take care to avoid burns: the hot plate is extremely hot. · Fill the coffee cup (about 60 cc, 2 fl. oz. ) by moving the coffee spout control from left to right (fig. · Prepare the cappuccino as described in the chapter "Preparing cappuccino coffee". [. . . ]