User manual DELONGHI DEHUMIDIFIER DEC16

[. . . ] Do not place the dehumidifier next to a radiator or other heat source as this will reduce its performance. For ongoing usage we suggest positioning in a hallway or on a landing. Please remember to keep internal doors ajar to allow air circulation. Before using your dehumidifier for the first time, it should be stood upright for 24hrs prior to use. [. . . ] (The dehumidification standby light comes on for the first 3 minutes after which the appliance starts dehumidifying). Leave the unit on this setting until signs of excess moisture (e. g. At this point select or and slowly turn the humidistat knob anti-clockwise until the dehumidification light switches off. The dehumidifier will then keep the humidity at the selected level automatically. 5 FUNCTION SELECTOR HUMIDISTAT KNOB Dehumidifier 5748009300 8-08-2002 15:22 Pagina 6 Selecting operating functions (DEC16 only) Functions selector Humidistat knob "Tank full / no tank" indicator light Dehumidifying indicator light Dehumidifying standby (lights up for the first 3 mins in dehumidifying mode) Functions Your appliance features 4 functions: air purification , low consumption dehumidification , comfort function , and maximum/clothes drying . Turn the function knob to select the functions, as required. Purification function This function circulates the air through the high-efficiency electrostatic filter, purifying it without dehumidifying. The filter is also active in all dehumidifying functions. Low consumption dehumidification function The appliance dehumidifies with maximum economy and at the lowest noise level (using the lowest fan speed). On reaching the required humidity level the appliance switches off Comfort function By using this function you can reach the desired comfort level of humidity faster. The appliance uses the higher fan speed. Dry function (clothes drying) For initial use and when required to work in very damp areas (e. g. for drying clothes), the dehumidifier works continuously (independent of the humidistat). Dehumidifier 6 5748009300 8-08-2002 15:22 Pagina 7 Maintenance Always remove the plug from the power socket before performing any cleaning or maintenance operations. For safety reasons, never wash the dehumidifier using a water jet. Cleaning the cabinet · Clean the appliance using a damp cloth then dry with a dry cloth. · Never use petrol, alcohol or solvents to clean the appliance. · Never spray the appliance with insecticides or similar. These could cause the paint to flake or plastic parts to warp. Cleaning the permanent air filter Your dehumidifier is fitted with a permanent air filter. If the filter is dirty, air circulation is compromised and the efficiency of the dehumidifying and air purifying functions decreases. It is therefore good practice to clean the filter at regular intervals. The frequency depends on the duration and conditions of operation. If the unit is used constantly or on a regular basis, you are recommended to clean the filter once a week. · Remove the air filter, by pulling it as shown in fig. · Use a vacuum cleaner to remove dust accumulations from the filter. If the filter is very dirty, wash in warm water and rinse several times. The temperature of the water should not exceed 40°C. After washing the filter, allow to dry completely before replacing it. Electrostatic purification filters (DEC 16) In addition to the permanent filter a second high-efficiency electrostatic filter which can capture very small particles (down to 0. 3 µm) is found on the permanent filter housing. The filter is active in all of the functions. The filter should be replaced regularly (depending on usage) fig, 4 If the appliance is not used for long periods · Unplug from the mains socket and empty the tank. · Clean and reposition the filter. · Cover the appliance so that dust does not build up. Accessories available for your dehumidifier Castors: a kit of 4 castors to allow you to wheel your dehumidifier from room to room, is available to order. [. . . ] Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. After replacement of a fuse in the plug, the fuse cover must be refitted. [. . . ]