User manual DELONGHI ELECTRIC HEATING CONVECTOR HR720B

[. . . ] Assembling the feet Fit the feet to the convector as follows: - Insert the foot ensuring that the bigger hole A on the foot coincides with the screw mounted on the base of the convector (see figure 1); then screw in the remaining three screws (see figure 2) which are supplied. Note: the convector mut be used only with the feet correctly fitted!- Before plugging the convector into the mains, check that your supply voltage is the same as that shown on the rating plate of the convector and that the electric installation is suitable to the power shown on the rating plate. [. . . ] - Do not block the outlet grilles at the top of the convector or the intake grille at the bottom of the convector . - The convector must be positioned at least 50cm from furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre. - Do not use this convector in rooms which have a floor area smaller than 4m2. - We recommend that you do not place the convector in a draught as this may adversely affect the convector 's operational efficiency. - The convector must never be placed immediately under a fixed mains socket. - A safety device intervenes and turns the convector off in the event of overheating or because the convector is positioned in a strong draught of air. To reactivate the convector , remove the plug from the mains, allow the convector to cool (for about 5 mins), remove the cause of the overheating/draught and then plug the convector back into the mains and turn it back on. - The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of the convector - In order to avoid any danger caused by an accidental resetting of the safety system, this convector must not be powered through an external timer. - As with any electrical convector , whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your convector , particularly in the vicinity of young children. Important: never cover this convector in any manner whatsoever while it is operating as this could lead to dangerous overheating. HR 4 GB OK 9-06-2004 10:27 Pagina 5 Warning - this appliance Before using this appliance ensure that the voltage indicated must be earthed on the product corresponds with the main voltage in your Green and Yellow to Earth home, if you are in any doubt about your supply contact your local electricity company. 13 amp The flexible mains lead is supplied connected to a B. S. 1363 fused plug Fuse having a fuse of 13 amp capacity. Should this plug not fit the socket outBrown lets in your home, it should be cut off and replaced with a suitable plug, to Live following the procedure outlined below. Note: Such a plug cannot be used for any other appliance and should Blue to Cord Clamp Neutral therefore be properly disposed of and not left where children might find it and plug it into a supply socket - with the obvious consequent danger. We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. [. . . ] If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. [. . . ]